Brocade Communications Systems SBCEBFCSW manual Squeezing the release-lever latch

Page 29

6.If you have not already done so, touch the static-protective package that contains the switch module to an unpainted metal part of the Blade unit for at least 2 seconds.

7.Remove the switch module from its static-protective package.

8.Squeeze the release-lever latch to move the insertion arm, as shown in the following illustration.

Release-lever latch

OK

2G

!

TX RX

!

0 FC 15

2G TX RX

!

Figure 4. Squeezing the release-lever latch.

9.Pull the release lever down to completely open the lever, as shown in the following illustration. When the lever is in the open position, you can correctly install the switch module in the Blade unit.

OK

2G

!

TX RX

!

0 FC 15

2G TX RX

!

Figure 5. Opening the release lever.

10.With the port side facing you and the release lever in the open position (perpendicular to the module), slide the switch module into the I/O bay until it stops.

Figure 6 on page 16 shows how to install a switch module in the rear of the SBCE unit.

15

Image 29

Contents Sbcebfcsw Brocade SAN Switch Module Installation Guide Contents Brocade SAN Switch Module Installation Guide Safety and regulatory information Electrical Safety General SafetyHandling electrostatic discharge-sensitive devices Viii Use safe practices when lifting Xx Caution Safety compliance Regulatory specifications and disclaimersElectromagnetic compatibility notices USA Xiii Xiv Brocade Enterprise SAN Switch Module Sbcebfcsw for Intel Resource CD Features and specificationsPage Fibre Channel switch-module standards and protocols Dimensions Related documentation SFP module at 2 Gbps ModePage Shows the major components of the switch module Major components of the switch moduleFibre Channel switch-module major components Brocade SAN Switch Module Installation Guide Installing and replacing a switch module Bay Fibre Channel switch-module function Installation guidelinesHandling static-sensitive devices Installing a switch moduleRemoving the acoustic attenuation module Squeezing the release-lever latch Installing a switch module Removing or replacing a switch module Removing a switch module Page Brocade SAN Switch Module Installation Guide Information panel Information panel LEDs and external Fibre Channel portsLEDs Fibre Channel switch-module LEDs. Notes Port speed Green Off Connecting to the switch module Configuring the switch module through the Telnet interfaceEstablishing a Telnet session through the management module Enter Network Password windowManagement-module main window Switch Management window showing switch-module 3 example Management-module password-change window Management-module command-line interface window Establishing a Telnet session in a command-line windowTelnet command-prompt window Brocade SAN Switch Module Installation Guide Connecting to the switch module Active Session from Same Client window Management-module main window Switch Management window showing switch module 3 example Advanced Web Tools interface window management-module view Establishing a Web-interface session through a Web browserAdvanced Web Tools interface window Web-browser view Optional features Brocade SAN Switch Module Installation Guide Before you call Getting Help and Technical AssistanceBrocade SAN Switch Module Installation Guide