Bradford-White Corp D-38T-155 service manual Select SET

Page 13

Troubleshooting

Step 2: Press “Set” button to enter setting mode. “Max Setpoint” will flash to indicate setting mode.

°F Max

Setpoint

idle

Status Operational

SELECTSET

Step 3: Press the “UP” or “DOWN” buttons to change the maximum setpoint value. This will limit the maximum setpoint

the user can select. Note: The maximum setpoint is approximately 180°F.

"Max Setpoint" continues to flash while making adjustments

°F

Max

 

 

Setpoint

%

idle

 

Status Operational

 

SELECT

SET

Step 4: Press “Set” button to confirm new “Max Setpoint” value and stop setting mode.

"Max Setpoint" stops flashing

°F Max

Setpoint

idle

Status Operational

SELECT%SET

Page 13

13

Image 13
Contents To be performed only by qualified service providers Service ManualTable of Contents Features of Honeywell Integrated Controls System Tools Required for Service Specifications Lockout Condition Sequence of OperationPins to black and white wires TroubleshootingVoltage at primary pins 1&3 white DefectiveExample of error code shown on control display Displaying temperature SensorsFrom previous Operate?Using Control Display for Servicing Water Heater Sensor is used Setpoint Display/Change Software Version Display only Select SET Display of Water Temperature ExitingSELECTServiceSETModeTo Display Flame Sense Current of the Pilot Flame Sensor To Display and Change Temperature SetpointSetpoint Flashes Selectset Idle Status Operational Error Code History Error Codes and Error History DisplayTo view previous error codes ExitingSELECTServiceSET Mode Error Code Definitions Press for 3 seconds to reset control in service mode Error Code Shown Water Heater DisplayThermostat Circuit Testing Service Procedure D24-IDo not reset the display from the hard lockout State without correcting the causeService Procedure D24-I Lower Sensor Upper SensorUpper thermister location Applicable models Pilot Operation Testing Service Procedure D24-II131 Pilot Inspection Probe Micro-amp readings MeterMeter Probe Micro Amp =Main Burner Operation Testing Service Procedure D24-III114 Heater. Refer to Installation Instructions Build-up causing restrictionSee Pilot Inspection section InspectionMain Burner & Pilot Removal and Inspection Service Procedure D24-IVMain Burner Removal Main Burner InspectionPilot Burner Inspection Pilot Burner RemovalFlame Rod Ferrule NutControl board replacement Control Board ReplacementTo remove lower sensor Flue Baffle Removal, Inspection Service Procedure D24-VService Procedure D24-VI Approximate Anode Rod Locations 15A 16/16A 17/17A Generic Parts List13A 14A 16A 17A6A 11A 10A 18A 15A 19A 12A 20A 14B 15B 19B 20B 17B18B 16B 12B10B 13BCO2 BTU/HECO GFIPage Page Parts@bradfordwhite.com Techserv@bradfordwhite.com