Bradford-White Corp D-38T-155 service manual ExitingSELECTServiceSET Mode

Page 21

Troubleshooting

Step 4:

Press the “Temperature Down” button to change to the previous code index, code #9.

idle

 

%

Status Operational

 

SELECT

SET

Step 5:

Press the “Select” button for code index #9 to view if there are any code numbers.

idle

Status Operational

SELECTSET

Step 6:

Continue pressing the “Temperature Down” button to change to the next error code index and press “Select” to view the error code number, if any, for that index number. Continue on to index #1, the oldest error code index. The water heater display will store up to 10 error codes with the oldest code starting in code index #1 with the most recent code in code index #10.

Step 7: 10 seconds after the last button press, the Water Heater Display will revert back to the current error code display. To exit Service Mode, either wait 30 seconds or press Temperature Up button and Select Button for 3 seconds.

°F setpoint%

idle

Statu Operational s

&ExitingSELECTServiceSET Mode

Page 21

21

Image 21
Contents To be performed only by qualified service providers Service ManualTable of Contents Features of Honeywell Integrated Controls System Tools Required for Service Specifications Lockout Condition Sequence of OperationPins to black and white wires TroubleshootingVoltage at primary pins 1&3 white DefectiveExample of error code shown on control display Displaying temperature SensorsFrom previous Operate?Using Control Display for Servicing Water Heater Sensor is used Setpoint Display/Change Software Version Display only Select SET Display of Water Temperature ExitingSELECTServiceSETModeTo Display Flame Sense Current of the Pilot Flame Sensor To Display and Change Temperature SetpointSetpoint Flashes Selectset Idle Status Operational Error Code History Error Codes and Error History DisplayTo view previous error codes ExitingSELECTServiceSET Mode Error Code Definitions Press for 3 seconds to reset control in service mode Error Code Shown Water Heater DisplayThermostat Circuit Testing Service Procedure D24-IDo not reset the display from the hard lockout State without correcting the causeService Procedure D24-I Upper Sensor Lower SensorUpper thermister location Applicable models Service Procedure D24-II Pilot Operation Testing131 Pilot Inspection Probe Micro-amp readings MeterMeter Probe Micro Amp =Service Procedure D24-III Main Burner Operation Testing114 Heater. Refer to Installation Instructions Build-up causing restrictionSee Pilot Inspection section InspectionMain Burner & Pilot Removal and Inspection Service Procedure D24-IVMain Burner Removal Main Burner InspectionPilot Burner Inspection Pilot Burner RemovalFlame Rod Ferrule NutControl Board Replacement Control board replacementTo remove lower sensor Flue Baffle Removal, Inspection Service Procedure D24-VService Procedure D24-VI Approximate Anode Rod Locations 15A 16/16A 17/17A Generic Parts List13A 14A 16A 17A6A 11A 10A 18A 15A 19A 12A 20A 14B 15B 19B 20B 17B18B 16B 12B10B 13BCO2 BTU/HECO GFIPage Page Parts@bradfordwhite.com Techserv@bradfordwhite.com