Troubleshooting
Step 2: Press the “Set” button to enter the setting mode. “Setpoint” will flash in the water heater display.
°F setpoint
idle
Status Operational
SELECTSET
Step 3: To raise the temperature setpoint, press the “Temperature Up” button until the desired temperature is shown on the water heater display.
NOTICE
The maximum temperature that can be set in the Water Heater Display is limited to the “Max Setpoint” described previously. To change the “Max Setpoint”, refer to the procedure “To Change the Maximum Setpoint Limit…" described previously under “Accessing the Service Mode on the Water Heater Display”.
WARNING Setting the water temperature to the maximum set point can result in scalding hot water delivered to the faucets. It is highly recommended that the maximum setpoint be adjusted to the lowest temperature possible for the needs of the installation. Make sure the water heater control display is not in a public area that can result in the temperature settings being improperly adjusted.
°F | setpoint | % |
| ||
idle |
|
|
Status Operational |
|
|
SELECT | SET |
|
Step 4: To lower the temperature setpoint, press the “Temperature Down” button until the desired temperature is shown on the water heater display.
"Setpoint" Flashes
°F setpoint
idle
Status Operational
SELECTSET
Page 16
16