GTO SL-1000, SL-2000 installation manual Control Board Settings, Right

SEQ1

SEQ2

PULL/PUSH

SNGL/DUAL

DIP switches

CONTROL BOARD SETTINGS

DIP SWITCHES

The four DIP switches on the control board match the operator with the type of gate on which it is mounted. For example, gates may open right to left or left to right. Prior to packaging, the GTO/PRO SL-1000 and SL- 2000 series control board was configured for a single slide gate that opens right to left. If your gate type matches this configuration, you DO NOT need to adjust the DIP switches. Proceed to the Potentiometers section on the next page. NOTE: The direction a gate opens is determined by standing inside the property and facing toward the gate.

NOTE: To change the DIP switch settings, you must turn the control box power switch OFF; move the switch; then turn the power back ON. Use a small screwdriver to move the switches.

PULL/PUSH: Set to PULL for slide gates that open RIGHT to

LEFT [factory setting]; PUSH for slide gates that open LEFT to

RIGHT.

SNGL/DUAL: Set to SNGL for a single gate leaf [factory setting]; ON DUAL for dual gate leaves.

SEQ1: Controls the opening order of dual gate leaves. See Setting the Control Board for Dual Gate Operator Installation on page 37 for more information. (the factory setting is OFF).

SEQ2: Controls the opening order of dual gate leaves. See Setting

the Control Board for Dual Gate Operator Installation on page 37 for more information

(the factory setting is OFF).

1 2 3 4

OBSTRUCT
	SENS.
MIN	MAX
LEARN

– PWR . SW .

+ BATT

18VAC		SOLAR		RED BLK	ORG BLU GRN CLS	OPN	RED BLK	ORG BLU	GRN	CLSEDG	OPNEDG
		–	+
~	~
								OPERATOR
							SECOND
				FIRST	OPERATOR
		IN
POWER

		AUTOCLOSE
				60
STATUS
			OFF		120
			INERTIA
			MIN		MAX
			OBSTRUCT
				SENS	.
PULL/PUSH			MIN		MAX
SNGL/DUAL				LEARN
SEQ1
SEQ2
	WHT
GRN ORG BLU		R	B	G
			RCVR
ACCESSORY
ALARM

20