Hague Quality Water Intl 60 SERIES manual Drain End Cap Assembly, H2086 Drain Line, Retainer

Assembly and Parts, Cont.

Drain End Cap Assembly

Figure 16: Drain End Cap Assembly

		Part #			Description	Quantity
	1	93808			O-Ring	1
	2	90268			Drain End Cap	1
	3	H2086-XX*			Drain Line Flow Control	1
	4	90267			Retainer	1
		90614-XX*			Entire Assembly (all the above parts)	1
90268 Drain End Cap			The Drain End Cap (90268) seals the left opening on the Main Valve Body. The opening is sealed
			with an O-Ring used as axial or “face” seal. The O-Ring sits in a groove in the End Cap. This
			groove must be free of defects such as pits or scratches and also free of debris. When
			assembling the End Cap to the Valve Body, care should be taken to make sure that the O-Ring
			stays in the groove in the End Cap. If misaligned, the O-Ring can become pinched and leak.
H2086 Drain Line			The Drain Line Flow Control (DLFC) maintains a constant (plus or minus 10%) backwash flow rate
Flow Control			at varying pressures. Care should be taken when replacing DLFCs to ensure that the correct rate
			is being used for a particular model. Refer to Specifications. When assembling the flow control,
			ensure that the rounded (radiused) side of the hole faces in toward the water flow.
			￿	H2086 - 2.4*
			￿	H2086 - 3.0*
			￿	H2086 - 5.0*
			￿	H2086 - 7.0*
90267 Retainer			The Retainer (90267) holds the backwash Flow Control (H2086) in place. One side is smooth and
			the other has a groove for a screwdriver. When assembling the retainer to the Drain End Cap
			(90268), the retainer should be screwed in until it stops. If the retainer is not fully engaged, the
			Flow Control may not function properly.

*Must specify drain line flow control size. XX Indicates the back wash flow rate in gpm. Example: 90614-2.4

WaterMax 60 Series Owner’s Manual 11/10/2008 38