GE GXSF30H Sanitizing Procedures, Specifications/Dimensions, 19″ 471⁄2″ 411⁄4″ 16″

Page 12

Installation Instructions

SANITIZING PROCEDURES

To complete the installation, do the following sanitizing procedures.

Care is taken at the factory to keep your water softener clean and sanitary. Materials used to make the softener will not infect or contaminate your water supply and will not cause bacteria to form or grow. However, during shipping, storage, installation and operation, bacteria could get into the softener. For this reason, sanitizing as follows is suggested when installing.

NOTE: Sanitizing is recommended by the Water Quality Association for disinfecting.

1.Be sure to complete all installation steps, including programming the control.

2.Pour about 3/4 oz. (112 tablespoons) of common 5.25% unscented household bleach (Clorox, Linco, Bo Peep, White Sail, Eagle, etc.) into the brinewell. Refer to illustration on page 5.

3.IMPORTANT: Press and hold for 3 seconds the faceplate RECHARGE button to start an immediate recharge. RECHARGE begins to flash in the display. The bleach will be drawn through the

water softener, and out the drain. This process takes approximately 2 hours.

4.If, after sanitization, water from the house faucet tastes salty or has a slight color, this is a preservative from the resin tank. Turn on the cold soft water faucets and drain for a few minutes or until clear.

NOTE: When the sanitizing recharge is over, all remaining bleach is flushed from the conditioner and your house COLD water supply is fully soft immediately. However, your water heater is filled with hard water and as hot water is used, it will refill with soft water. When all the hard water is replaced in the water heater, hot only and mixed hot and cold water will be fully soft. If you want totally soft water immediately, after the above recharge, drain the water heater until the water runs cold.

WARNING: If you do drain the water heater, use extreme care as the hot water could cause burns. Turn the water heater off prior to draining.

SPECIFICATIONS/DIMENSIONS

 

GXSF30H

 

 

Rated Capacity*

11,800 grains with 2.3 lbs. of salt

 

25,300 grains with 7.4 lbs. of salt

 

30,200 grains with 12.5 lbs. of salt

 

 

Rated Efficiency**

5,120 grains/lb. @ 2.3 lbs. of salt

 

 

Amount of High Capacity Resin (lbs/cu. ft)

40.6/0.78

 

 

Resin Tank Nominal Size (in., dia. x height)

8 x 40

 

 

Service Flow Rate (gpm)

7.5

 

 

Water Supply Maximum Hardness (gpg)

95

 

 

Water Supply Maximum Clear Water Iron (ppm)***

7

 

 

Water Pressure Limits (min.–max. psi)****

20–125

 

 

Pressure Drop at Rated Service Flow (psig)

14

 

 

Water Temperature Limits (min.–max. °F)

40–120

 

 

Maximum Flow Rate to Drain (gpm)

2.0

 

 

This system conforms to NSF/ANSI 44 for the specific capacity claims as verified and substantiated by test data.

*Testing was performed using pellet grade sodium chloride as the regenerant salt.

**Efficiency rating is valid only at the lowest stated salt dosage. This softener was efficiency rated according to NSF/ANSI 44.

***Extent of iron removal may vary with conditions. The capacity to reduce clear water iron is substantiated by WQA test data. State of Wisconsin requires additional treatment if water supply contains greater than 5 ppm clear water iron. Use of Diamond Crystal® Red•Out® or Super Iron Out® will improve iron removal. Refer to Cleaning Iron Out of the Water Softening System section.

****Canada working pressure limits: 1.4–7.0 kg/cm2.

3

38

 

INLET

 

 

OUT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INLET–

 

 

 

 

 

 

 

 

 

OUTLET

 

 

 

 

 

 

19

4712

4114 16

12

Image 12
Contents Safety Information Care and Cleaning7283918 215C1173P021 49-5017706-06 JR Write the model and serial numbers here Model #Safety Precautions Before Beginning Installation Important Installation RecommendationsWhere to Install the Softener Unpacking and InspectionTransit Plan HOW YOU will Install the Softener Typical Installation IllustrationInstall Bypass Valve Before YOU BeginConnect and RUN the Valve Drain Hose Plumb in and OUT Pipes to and from SoftenerInstall the Brine Tank Connecting a Rigid Valve Drain TubeInstall Grounding Clamp ADD Water and Salt to the Brine TankWith salt Connect to Electrical Power Programming the ControlSET Present Time of DAY SET Water Hardness NumberOptional Control Settings SYSTEM/ELECTRONIC DiagnosticsError Signals SET Recharge Starting TimeSanitizing Procedures SPECIFICATIONS/DIMENSIONS19″ 471⁄2″ 411⁄4″ 16″ About the water softener system Cleaning the Nozzle and Venturi Assembly Breaking a Salt BridgeFeature Optional Recharge Controls Feature MemoryFeature/Service Automatic Electronic Diagnostics Normal Operation, Control DisplaysService Electronic Demand Time Features and Service Service Timer/Softener, Service Checkout ProcedureTo remove an error code 1. Unplug transformer ERRIf the code was changed, make ALL the timer settings Open a Nearby Soft Water FaucetIf the water softening system does not draw brine, check Care and cleaning of the water softening system Cleaning Iron Out of the Water Softening SystemChecking the Salt Storage Level and Refilling Before you call for service… What To DoNo soft water Taken not plumbed to soft waterExcessive/high level Water in brine tankBrown/yellow colored Water after installation Salty tasting orBrown/yellow Colored water Resin beads showingParts list Parts list Parts catalog General Electric Parts CatalogSupport Screen What Is Not Covered For The Period We Will ReplaceWarrantor General Electric Company. Louisville, KY GE Water Softening System Warranty. For Customers in Canada For The Period Of We Will ReplaceWarrantor Mabe Canada INC One YearCómo limpiar la ensambladura De agua Cuidado y limpiezaDe averías Advertencia Advertencia No use con aguaInstrucciones de instalación Recomendaciones Importantes Para LA InstalaciónDesempacado E Inspección Donde Instalar EL DescalcificadorHerramientas Y Materiales Necesarios Para LA Instalación Use la válvula de bypass incluida para instalarPlanifique LA Instalación DEL Descalcificador Ilustración DE Instalación NormalAntes DE Comenzar Instale LA Válvula DE BypassRetire el descalcificador del lugar de instalación Conecte LAS Tuberías QUE Entran Y Salen DEL DescalcificadorSalmuera Y LA Manguera ContCómo Conectar UN Tubo DE Drenaje DE Válvula Rígida Instale LA Abrazadera DE Tierra Conectar a LA Fuente Eléctrica Programación DEL ControlAjuste LA Hora DEL DÍA Ajustes Opcionales DE Control DEL SistemaEficiencia DE LA SAL Botones UP Down Para fijar laProcedimientos DE Desinfección En la fábrica se siguen los cuidados para mantenerNi infectarán su suministro de agua ni causarán que Sobre el sistema de descalcificación de agua Cómo romper un puente de sal Cómo limpiar la ensambladura de la boquilla y el Venturi Operación normal, Pantalla de control Función Controles opcionales de recargadoFunción Memoria Característica/Servicio Diagnóstico electrónico automáticoVisualizado Servicio Diagnóstico electrónico iniciado manualmente Abra UN Grifo DE Agua Descalcificada QUE Esté CercaServicio Inspección manual del avance de la recarga Cuidado y limpieza del sistema de descalcificación de agua PrecauciónAntes de llamar para solicitar servicio… Qué hacerConsejos para la identificación y solución de averías El agua sabe a sal o tiene Notas Ge.com Lista de partes Ge.com Catálogo de partes Catálogo DE Partes DE General ElectricInterruptor Garantía GE para el Sistema de Descalcificación de Agua Por el período de ReemplazamosLo que no está cubierto Soporte al Consumidor Página Web de GE Appliances Solicite una reparaciónGarantías ampliadas Piezas y accesoriosSchedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design Studio

GXSF30H specifications

The GE GXSF30H is a highly regarded water filtration system designed to deliver clean, filtered water for residential use. This model features an advanced filtration process that effectively removes impurities and contaminants, ensuring that the water you drink is safe and refreshing. With its sleek design and efficient performance, the GXSF30H appeals to many homeowners looking for quality water solutions.

One of the key features of the GE GXSF30H is its high capacity. This water filtration system can treat up to 30,000 grains of hardness, making it suitable for families of various sizes. The generous capacity means that it requires less frequent maintenance and provides continuous access to soft water, enhancing your overall home experience.

The GXSF30H employs a modern ion-exchange technology that works by exchanging hard minerals like calcium and magnesium with sodium ions. This process effectively softens the water, reducing scale buildup in pipes and appliances, which can prolong their life and improve efficiency. As a result, homeowners save on energy costs associated with heating water and maintaining appliances.

Another standout characteristic of the GE GXSF30H is its user-friendly interface. The system features an intuitive digital control panel that provides real-time feedback on the system’s performance, making it easy to monitor water quality and system efficiency. This panel also includes diagnostic alerts to notify users when maintenance is needed, ensuring the system runs optimally at all times.

In terms of installation, the GE GXSF30H is designed for straightforward setup, compatible with most plumbing systems. It comes equipped with a comprehensive installation kit, allowing most homeowners to complete the installation without the need for professional assistance.

Finally, the GE GXSF30H is backed by a reputable brand known for quality and reliability. GE’s commitment to innovation means that the GXSF30H incorporates the latest technologies to meet consumer needs and environmental standards. This water filtration system offers not just functionality but also a long-term solution for ensuring clean and enjoyable water for everyday use. Whether you're concerned about hard water issues or simply desire better-tasting water, the GE GXSF30H is a solid investment for your home.