Installing the Status Indicator
The produce preserver comes with a status indicator, which should be activated and installed at the same time the pouches are installed.
MONTHS
REPLACE
1.Place the indicator
2.Apply pressure to the bubble on the back of the indicator until the bubble pops, to activate the indicator.
3.Slide open the cap on the top of the produce preserver housing.
4.Place the indicator in the top of the housing, facing outward.
5.Slide the cap closed, and check that the indicator is visible through the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator’s bubble has not been popped.
Accessories
The following accessories are available for your refrigerator. To order an accessory, contact us and ask for the Part Number.
In the U.S.A., visit our webpage www.maytag.com/accessories or call
In Canada, visit our webpage www.whirlpoolparts.ca or call
affresh® Stainless Steel Cleaner: In U.S.A., order Part #W10355016 In Canada, order Part #W10355016B
affresh® Stainless Steel Wipes: In U.S.A., order Part #W10355049 In Canada, order Part #W10355049B
Replacing the Produce Preserver
The disposable pouches should be replaced every 6 months or when the status indicator changes completely from white to red.
To order replacements, contact us. See “Accessories” for information on ordering.
1.Remove the used pouches from the produce preserver housing.
2.Remove the used status indicator.
3.Install the replacement pouches and status indicator using the instructions in the previous sections.
Accessories
affresh® Kitchen & Appliance Cleaner:
In U.S.A., order Part #W10355010
In Canada, order Part #W10355010B
Water Filter:
Order Part #W10413645A or FILTER2
Air Filter:
Order Part #W10311524 or AIR1
Produce Preserver:
Order Part # W10346771A or FRESH1
Water Filter, Air Filter and Produce Preserver Bundle Pack:
Order Part # W10413643BL
17