KitchenAid W10379132A manual Classic and Architect Series Custom Side Panels, Refrigerator

NOTE: When creating a panel with face detail, the offsets will be hidden and must be accounted for in order to center the detail in the top grille.

		¹⁄₄"
		(6.35 mm) max.
¹⁄₂"	Top
(1.3 cm)
min.

Center face detail between offsets

³⁄₈"

(9.5 mm)
min.	Bottom
		¹⁄₄"
		(6.35 mm) max.

Door Panel – Routing Requirements

If the custom panels are thicker than ¹⁄₄" (6.35 mm), then all edges of the panels must be routed. If the standard handle is used, rout the entire handle side of both panels 3¹⁄₄" (8.25 cm) to allow for finger clearance. Then rout the hinge side of the refrigerator panel 1" (2.54 cm). Rout both sides of the freezer panel 1" (2.54 cm).

Standard Handle – Top View

Door Panel - Side View

	¹⁄₄"
	(6.35 mm)
Panel	max.
	¹⁄₂" (1.3 cm)
	min.

Extended Handle - Top View

		1"
	¹⁄₄"	(2.54 cm)
		max
	(6.35 mm)	Hinge Side
Handle	Door	Door
	Panel	Panel
		1"
		(2.54 cm)

Classic and Architect® Series

Custom Side Panels

Handle

3¹⁄₄"

(8.25 cm) min.

¹⁄₄" (6.35 mm) max.

2" (5 cm)

min.

Hinge Side

Door	Door
Panel	Panel

1"

(2.54 cm)

Custom side panels may be needed when not enough space is available to have cabinets on both sides of the refrigerator or when the refrigerator is placed and the end of a cabinet run. You may choose an Inset, Flush, or Recessed Inset panel installation.

Refrigerator and Side Trim Dimensions

The width and height of a side panel are determined by the type of installation you are planning.

NOTES:

■ The dimensions shown are actual product dimensions and

may not reflect the needed panel installation dimensions.

If an extended handle kit is used, rout the handle side ¹⁄₄"

(6.35 mm). All other routing dimensions would remain the same as the standard handle. Make sure your product location will allow doors with extended handles to be opened to 90 degrees. See “Door Swing Dimensions.”

For more information on ordering extended handles, see “Classic Series Factory Panels and Kits.”

NOTE: For both types of handles, rout the top and bottom edges of the refrigerator panel ¹⁄₂" (1.27 cm). Rout the bottom of the freezer panel ¹⁄₂" (1.27 cm).

■	The side panel should be a minimum of ¹⁄₂" (1.27 cm) thick
	to avoid warping.
■	If the opening depth is 25" (63.5 cm) or more, you may
	want to install a support board on the rear wall.

Refrigerator

24¹⁄₈"

(61.3 cm)

23¹¹⁄₁₆"

(60.3 cm)

23¹⁄₂"

(59.7 cm)

17