KitchenAid KSSC36QMS Location Requirements, Opening Dimensions, Model Width a as shown above

Location Requirements

The refrigerator can be recessed in an opening between cabinets	■ A grounded 3 prong electrical outlet should be placed within
or installed at the end of a cabinet run using a side panel to	4" (10.2 cm) of the right side cabinets or end panel. See
enclose the refrigerator.	“Electrical Requirements” for additional information.
	■ The water shutoff should be located in the base cabinet on
WARNING
	either side of the refrigerator or some other easily accessible
	area. If the water shutoff valve is not in the cabinets, the
	plumbing for the water line can come through the floor or the
	back wall. See “Water Supply Requirements” for more
	information.

Explosion Hazard
Keep flammable materials and vapors, such as	80" - 90"
gasoline, away from refrigerator.
	(203-229 cm)
		4"
Failure to do so can result in death, explosion, or fire.
		(10.2 cm)
IMPORTANT:
■ Observe all governing codes and ordinances.
■ It is recommended that you do not install the refrigerator
near an oven, radiator, or other heat source.	83¹⁄₄" (211.5 cm) min.
■ Do not install in a location where the temperature will fall	84³⁄₄" (215 cm) max.
	to bottom of solid soffit
below 55°F (13°C).
■ Floor must support the refrigerator weight, more than
600 lbs (272 kg), door panels and contents of the
refrigerator.		77"
■ Ceiling height must allow for side tipping radius. See
		(196 cm)
“Tipping Radius.”
■ Location should permit doors to open fully. See “Door
Swing Dimensions.”	A
■ Location must permit top grille removal. See “Opening	Width
	(see chart following)
Dimensions.”
Opening Dimensions		6"
		(15.2 cm)
■ The solid soffit must be within 1" (2.5 cm) maximum above
the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or		3"
one is not available, then the refrigerator must be braced to		(7.6 cm)
prevent tipping during use.
If the anti-tip boards are needed, they must be attached to	11"
the rear wall studs 80" to 90" (203 cm to 229 cm) above the
floor. See “Install Anti-Tip Boards” for more information.	(28 cm)
NOTE: A clearance of ¹⁄₂" (1.3 cm) must be maintained above	6"	6"
the top grille in order for the top grille to be removed.	(15.2 cm)	(15.2 cm)
	23¹⁄₂"
	(60 cm) min.

¹⁄₂"

(1.3 cm)

Model Width A (as shown above)

3635¹⁄₂" (90.2 cm)

4241¹⁄₂" (105.4 cm)

4847¹⁄₂" (120.7 cm)

16