3.Remove one end cap by loosening the nuts and sliding off the end cap.
A |
|
C |
|
B |
|
D |
|
A. Bottom rail | C. End cap |
B. Nuts | D. Top rail |
4.Slide the panel into the top grille channel and reattach the end cap.
A
A.Panel
5.Replace the top grille in the cabinet side trims and pull the panel down slightly to lock it into place.
BAB
A. Top grille
B. Cabinet side trim
Install OverlaySeries Custom Panels
IMPORTANT:
■Install the custom handles prior to installing the panels on the refrigerator. For more information on KitchenAid custom handle selection, refer to the KitchenAid Catalog, visit www.kitchenaid.com, or call
In Canada, visit www.KitchenAid.ca, or call
■Create custom door overlay panels according to the specifications in the “Overlay Series Custom Panels” section.
■KitchenAid is not responsible for the removal or addition of molding or decorative panels that would prevent the refrigerator from being serviced.
Door Panel Installation
1.Remove all tape and door bracing from the refrigerator and freezer doors.
2.Open the refrigerator and freezer compartment doors.
3.Remove the handle side and top trims.
A 
A
A.Trims
4.Slide the custom panels into the bottom and hinge side trims on the refrigerator compartment and freezer compartment doors, making sure that the backer panel fits into the hinge side trims.
AA
A.Panels
5.Reinstall the
6.Remove the protective skin from the screw covers. Snap the screw covers into the handle trim section.
22