KitchenAid 2309069A, KSSC36QMS manual Level Refrigerator, Adjustand Remove Doors, Door Removal

Top Grille Panel

1.Grasp both ends of the top grille.

2.Push straight up, then pull straight out. Place the top grille panel-side down on a soft working surface.

BAB

A. Top grille

B. Cabinet side trim

3.Remove one end cap by loosening the nuts and sliding off the end cap.

A
C
B
D
A. Bottom rail	C. End cap
B. Nuts	D. Top rail

4.Slide the panel into the top grille channel and reattach the end cap.

A

A.Panel

5.Replace the top grille in the cabinet side trims and pull the panel down slightly to lock it into place.

BAB

A. Top grille

B. Cabinet side trim

Level Refrigerator

NOTE: Classic and Overlay Series door panels must be installed before leveling.

1.Open the doors and place the level on top of the refrigerator frame as shown. Check to see whether the refrigerator is level from left to right.

A

B

B

A. Level to check left to right leveling

B. Level to check front to back leveling

2.Use the leveling bolts to adjust the leveling legs until the refrigerator is level from left to right.

A	A
B	B

A. Rear leveling bolt

B. Front leveling bolt

3.Place the level(s) on shelf or shelves. Check to see whether the refrigerator is level from front to back.

4.Use the leveling bolts to adjust the leveling legs until the refrigerator is level from front to back.

5.Be sure that all four leveling legs contact the floor and support the full weight of the refrigerator.

6.Make final check to ensure the refrigerator is level.

Adjustand Remove Doors

Door Removal

NOTE: Do not remove the two ¹⁄₄" hex-head mounting screws.

A

B

A.Torx®† 27 flat-head mounting screws

B.¹⁄₄" hex-head mounting screws

†®TORX is a registered trademark of Textron Innovations Inc.

23