3-Wire Electrical Connection
Use this method only if local codes permit con- necting a
NOTE: Do not loosen the
1.Connect the neutral (white) wire of the power supply cord to the center, silver-
colored terminal screw on the terminal block, and secure it with one of the 3/8″ brass nuts that you set aside earlier.
2.Connect the remaining two power supply
cord wires to the outer terminals of the terminal block, and secure them with 3/8″ brass nuts.
3.Tighten the strain relief screws to secure the power supply cord.
4.Install the terminal block cover.
| line 2 |
ground | neutral wire |
link | (white wire) |
line 1 | U.L. listed conduit |
| |
| connector and power |
| supply cable |