•Clean unit with a damp clean paper towel. To remove more stubborn spots, use a slightly dampened non- impregnated plastic or nylon pad specially made for
•Use liquid cleansers to remove any discoloration, especially in hard water areas. A
•Apply
•Any smearing or hazing on the surface may be removed with a lightly dampened paper towel, and polished with a soft dry cloth.
•Do not use a sponge or a dishcloth. They may leave a film of
Warning
Personal Injury Hazard
•Note: If a wet paper towel is used to remove spillovers from warm cooking area, be careful to avoid steam burns.
•Never mix different household cleaning products.
Chemical mixtures may interact, with objectionable or even hazardous results.
Do Use
Ceramic glass
Do Not Use
1.Household detergents and bleaches.
2.Impregnated plastic or nylon pads.
3.Soap pads; these will scratch and mark.
4.Household abrasive powders except where specified; these may scratch depending on the pressure applied in use.
5.Chemical oven cleaners, e.g. aerosols and oven pads. These are caustic cleaners, and may etch the surface.
6.Rust stain or bath and sink stain removers, as these will mark and etch the surface.
7.Metal scrubbers.
How To Deal With Burned-On Spots
1.Make sure area to be cleaned is warm to the touch.
2.The careful use of a stainless steel razor blade held at approximately 30 degrees to the surface can be used to remove stubborn
3.Use
If after the use of recommended materials there are some persistent stains or marks on the cooktop, the unit should be cleaned using a liquid cleanser. This will remove any accumulated residue of
Any smearing or streaking on the surface may be removed with lightly dampened paper towel and polished with a soft dry cloth.
Metal Marks
Certain metal pots, especially those with aluminum bottoms may leave marks on the surface, especially if the pan is allowed to slide. Use the
Caution
Product Damage Hazard
Ceramic glass
Important Notes
1.In the event of the cooktop being scratched, soil will collect and appear as fine lines. These are not fully removable, but can be minimized by the daily use
of
2.Soil from sugar solutions must be removed from the cooktop before the syrup has set, otherwise it can permanently bond to the ceramic surface.
Electric Surface Elements
Solid Cast Elements
Before using your solid elements for the first time:
Heat the elements at max without a pan for 3 to 5 minutes or until smoking stops. The smoking is normal and non toxic.
Solid elements are sealed with a lacquer coating that prevents corrosion. This coating must be burned into the elements to be effective in protecting against rust. The coating will be transferred to the bottom of pans if this procedure is not done.
Because solid elements are different from coil elements, you can expect to see differences in cooking performance, cleaning and safety.
11