KitchenAid KGRT500 warranty Set stop time, Complete entry

Page 49

Using the Self-Cleaning Cycle

3. Press Stop Time pad.

PRESS	YOU SEE
STOP	ON	O
	ON

TIME
		STOP
		TIME

4. Set stop time.	PRESS	YOU SEE
Example for 7:00:	7	ON	O
Example for 7:00:	7

	0		STOP
			TIME
	0	(display shows stop
	0	time of 7:00)

5. Complete entry.

NOTE: The door will lock right after you press START.

When the start time is reached:

NOTE: After 30 minutes, the broil burner symbol will turn off and the bake burner symbol will turn on.

PRESS	YOU SEE
	ON	O
START	ON
START		HR MIN
		DELAY
		CLEAN
		DOOR LOCKED
		TIME

YOU SEE

	ON	O
	ON
	HR	MIN
	DOOR LOCKED	CLEAN
	DOOR LOCKED	TIME
		TIME

6.After the Self-Cleaning cycle ends:

NOTE: You can run a second Self- Cleaning cycle right after “DOOR LOCKED” disappears from the display.

YOU SEE

	ON	O
	ON
	TEMP PROBE	TIMED DELAY
O	CONTROL	CLEAN
O	DOOR LOCKED	STOP
F	START ?	COOK TIMER

Image 49

Contents Use and Care Guide Range SafetyPart no Rev. a Table of Contents Throughout Canada for assistance U.S.A830 a.m. 6 p.m. EST Your safety and the safety of others is very important Range SafetyOn next For units with ventilating hood For self-cleaning rangesFeature locations Parts and FeaturesSurface burner controls Models KGST300 and YKGST300Models KGRT500 and YKGRT500 Parts and FeaturesOven vent When handling the drawerStorage drawer Removing the storage drawerAnti-tip bracket Using the surface burners Using and Caring for Your CooktopWhen to use the left rear and right front burners When to use the left front and right rear burnersBurner heat settings How to use the surface burnersFire Hazard Setting Recommended USE Case of a prolonged power failureCookware tips Energy saving tipsHome canning information To protect your cooktopSurface burners Caring for your cooktopTo adjust the flame height follow the instructions below Adjusting the height of top burner flamesCleaning your cooktop Unplug range or disconnect power Using and replacing the surface lightPlug in range or reconnect power To turn the surface light on or offUsing the electronic oven control Using and Caring for Your OvenDisplay/clock Open the door Fahrenheit/CelsiusPress the Number Pads 1, 2, and 3, in that order Start ovenDisable/enable audible signals Repeat Steps 1-5 to turn the signals back on Press Timer Set/Start padSnd and Off will appear on Display Using the control lock Press the Number Pads 7, 8, and 9, in that order Using the Sabbath modePress Number Pad Press StartSetting your range for the Sabbath† Press Number Pads to set the temperature you wantFor 5 seconds Open the door Press and hold Number PadCase of a power failure Setting the clockCanceling an operation Starting an operationStart Timer Using the timerStart clock To cancel the timer during its operation To change the timer during its operationBaking or roasting Position racksSet temperature optional Choose baking/roasting settingWhen baking, preheat oven Put food in ovenBaking tips Cooking tipsBakeware tips Oven Approximate Cooking Time Food Temperature Baking chartRoasting tips Standing rib Beef Rolled ribRump roast Lamb LegPress Bake Adjusting oven temperatureBroiling How to determine the amount of adjustment neededPosition rack and close door After preheating, put food in oven Preheat broiler for 5 minutes before usingTo ensure adequate grease drainage Broiling tips Completely close doorBroiling chart Timed cooking Choose Bake settingTo start baking/roasting now and stop automatically Prepare ovenTo delay start and stop automatically When baking/roasting is doneSet cook time Set stop time Press Stop Time padExplosion Hazard Cleaning your oven and controlsDo not clean in Self-Cleaning cycle. See Do not use abrasive or harsh cleansersExterior surfaces They may damage the finishReplacing oven lights Models with side halogen lights Using and replacing the oven lightsReplacing the oven light models with light on back wall Before you start Using the Self-Cleaning CycleSetting the controls Before setting the controlsTo start cleaning immediately Press Clean padAfter the Self-Cleaning cycle ends Set cleaning time optionalTo delay cleaning start time Complete entry Set stop timeTo stop the self-cleaning cycle at For best cleaning resultsHow the cycle works Any timeIf nothing operates, check the following TroubleshootingOther possible problems and their causes Control knobs will Not turn Self-Cleaning cycleWill not operate Cooking results are notIf you need assistance or service in the U.S.A Requesting Assistance or ServiceIf you need service† For further assistance If you need assistance or service in CanadaToll free, 830 a.m. 6 p.m. EST, at Topic IndexIndex Purchase Warranty

Using the Self-Cleaning Cycle

3. Press Stop Time pad.

4. Set stop time.

5. Complete entry.

START

6.After the Self-Cleaning cycle ends: