KitchenAid KAD-9 manual Custom Front Panels Dimensions

Custom Front Panels

1.Prepare the custom front panels to speci- fications shown below.

2.Mount the handle to the custom panel. The screws must not extend beyond the back surface of the panel. (The handle is customer supplied, and the location is customer preference.)

3.Measure and mark the vertical centerline and horizontal position line on the back of the front panels.

	mark horizontal line
Top Panel -
1-7/16" (36.5 mm)
Bottom panel -	mark centerline
1-3/16" (30.2 mm)

Custom Front Panels Dimensions

9"

(22.9 cm)

medallion cutout area

Top panel

(front view)

2-5/16"

(5.9 cm)

15-5/8" (39.7 cm)

5"

(12.7 cm)

	end may be round
	or squared off
	1-9/32"
1-7/32"		(32.6 mm)
		max.
(30.8 mm)			1/4"

(6.4 mm)

23-7/16" (59.5 cm)

9"

(22.9 cm)

medallion cutout area

Bottom panel

(front view)

2-1/8"

(5.4 cm)

14" (35.6 cm)

5"

(12.7 cm)

1-13/64"

(30.6 mm)

2-13/32"

(60.8 mm)

Medallion cutout

(front of panel)

NOTE: Do not cut beyond outline of medallion cutout shown above.

Rout a 1/4" (6 mm) radius around back side of medallion cutout.

23-7/16" (59.5 cm)

Upper and lower panel minimum thickness is 5/8" (16 mm). Panel thickness above 11/16" (18 mm) can be accommodated but product depth will increase accordingly.

Custom front panel material must be suitable for damp conditions or adequately sealed to withstand moisture. Using a moisture resistant material can provide additional protection. Taping edges alone may not provide adequate sealing. For painted panel, paint all rear edges to improve sealing.

2-16