HSN_3n1BlenderManual 6/25/10 11:07 AM Page 17
Using Your
Citrus Juicer Attachment
| 1 | Place the appliance on a flat, stable, level |
|
| surface where it cannot fall. |
| 2 | Place the Mixing Bowl on the Motor Housing |
|
| with the handle at a 90 degree angle (see |
|
| Figure 6). Rotate the Mixing Bowl clockwise |
|
| as far as possible until you hear it click into |
Figure 14 |
| place (See Figure 7). |
|
| Place the Accessory Shaft into the mixing |
| 3 | |
|
| bowl over the center hub |
| 4 | Place the assembled citrus juicer |
|
| attachment on top of the mixing bowl with |
|
| the tab of the citrus juicer strainer slightly to |
|
| the right of the bowl handle (See Figure 14). |
Figure 15 | 5 | Rotate the citrus juicer strainer until the |
| ||
|
| tab lines up with the mixing bowl handle |
|
| (See Figure 15). |
| 6 | Pull the Power Cord out out of the Storage |
|
| Cavity at the rear of the Motor Housing. |
|
| Ensure that the cord is over the larger |
|
| opening in the cord storage area and not in |
|
| the locked position, see Figures 10 and 1 1. |
| 7 | Insert the plug into the wall outlet and turn |
|
| the power switch on the side of the Motor |
|
| Housing to the ON position. |
Using Your
Citrus Juicer Attachment cont.
If after plugging the cord in, all indicator lights are flashing, the Mixing Bowl and/or the Lid is not placed correctly on the Motor Housing. For safety reasons it is not
possible to switch on the appliance in Food Processor Mode both Bowl and Lid are properly assembled. Check the position
of the Bowl and the Lid and ensure that it matches Figures 7 & 9. When the Mixing Bowl and the Lid are fitted correctly, only the Standby Indicator Light flashes. Only then can the appliance be operated.
8When processing citrus, we recommend speed I only. Apply steady pressure over reamer. If juicer is not passing through to bowl turn motor off and clean pulp from strainer. You can turn the motor off by pressing the Selected Speed button. Switch the power off by pressing the power switch, located on the right side of the Motor Housing and unplug from the wall outlet.
9When bowl reaches the 3 cup mark turn motor off and pour out contents
10To remove strainer rotate citrus juicer housing slightly to the right (See Figure 14) and lift straight up.
Your
1)Time Protection: After two minutes of continuous operation, the motor will shut off. Fifteen seconds before switching off, the Standby Indicator Light will begin to flash. This prevents the motor from overheating during use; and
2)Overload Protection: In the event of an electrical overload, the motor will automatically shut off. Simply unplug the unit from the outlet. Wait at least 15 seconds before using again.
Wait at least 15 seconds before using again by pressing the Speed Button to restart.
17 | 18 |