HSN_3n1BlenderManual 6/25/10 11:08 AM Page 19
Maintenance and Cleaning
CAUTION: To avoid a laceration hazard, extreme care must be used when handling discs, blades and blade assemblies. They are precision- honed and extremely sharp.
•Turn the power switch off, located on the right side of the Food Processor Motor Housing. Remove the plug from the wall outlet.
Food Processor
•If using the Processing Blade, remove from the Accessory Shaft, press the two side lock tabs in, and carefully the lift the blade off the Shaft. See Figure 12. If using the Cutting Discs, remove from the Spindle by grasping from the white center ring and lifting straight up.
•Clean the Mixing Bowl, Lid and all the Accessories, except the Motor Housing with warm, soapy water and dry thoroughly. You can also clean the Accessories in the top rack of your dishwasher.
CAUTION: Be careful when attaching and removing accessories. The Processing Blade, the Slicing Disc and Shredding Disc are sharp.
•Clean the Motor Housing and the Power Cord with a damp cloth and dry thoroughly.
•Make sure no moisture comes into contact with the appliance’s electrical parts, never immerse the appliance, the Power Cord or the plug in water or other liquids.
•Never use aggressive or abrasive cleaning products or sharp objects (such as a knife or a hard brush) to clean the appliance.
19
Maintenance and Cleaning cont.
Blender
•You can use the frozen drink mode to clean the Blender Jar by placing two cups of warm water in the Jar with a drop of dishwashing detergent. Let the Blender run for the full cycle. Rinse and repeat if necessary.
•If food is stuck to the Blade Assembly, you can remove it from the Blender Jar for cleaning. The Filler Cap also acts as a Blade Assembly removal tool. Turn the Blender upside down and place the open end of the Filler Cap over the center of the blade. Make sure no moisture comes into contact with the appliance’s electrical parts. Turn the Filler Cap clockwise about
•To replace the Blade Assembly, ensure that the Silicone Gasket is properly placed over the Blade Assembly. Line up the four cutouts on the Blade Assembly with the four tabs on the Blender Jug. Use the Filler Cap to lock the blade into place by turning counter clockwise about a half inch until it stops.
•The Blender Jug with Blade Assembly, Lid and Filler Cap can be washed in warm, soapy water or placed in the top rack of the dishwasher.
Citrus Juicer
•Remove the Reamer, Strainer, Accessory Shaft, and Mixing Bowl and clean these parts with warm soapy water and dry thoroughly. These parts can also be placed in the top rack of your dishwasher.
•The Motor housing can be cleaned with a damp cloth. Do not immerse into any liquid.
Storage
1 | Place the discs in the storage tray at the | ||
|
| bottom of the Motor Housing as shown in | |
|
| figures 16 and 17. | |
2 | Push the Power Cord into the storage space | ||
|
| at the back of the appliance. | |
Figure 16 | |||
| |||
|
|
| |
|
|
|
Figure 17
20