HSN_3n1BlenderManual 6/25/10 11:06 AM Page 7
Before Your First Use
Wash all parts, except Motor Housing or Cord, in warm soapy water and dry thoroughly. Never immerse Motor Housing or Cord in water as this will damage the unit.
Using Your Blender
Using Your Blender cont.
| • Note: the Blender works very fast. | |
| In a few seconds the ingredients will | |
| be processed. The consistency of the | |
| ingredients increases with longer | |
| blend times. | |
| 7 If necessary, you can add ingredients | |
Figure 4 | through the cover by removing the center | |
| cap of the Lid: turn the Filler Cap counter- | |
| ||
| clockwise and remove. If the pieces are too | |
| large for the filling opening then switch off | |
| the Blender, remove the Lid, and add the | |
| ingredients. Put the Lid back on the Jug | |
| before switching the Blender on again. | |
| 8 Once you have processed the required | |
Figure 5 | ||
quantity of ingredients | ||
| ||
| you can switch the appliance off (press the |
6 with rrow
Figure 1
Figure 2
Figure 3
1Place the appliance on a flat, stable, level surface where it cannot fall.
2Place the Blender Jug on the Motor Housing. Rotate the Blender Jug clockwise as far as possible until you hear it click into place (see Figures 1 and 2).
3Cut the ingredients into pieces that fit in the Jug. Do not cut into pieces that are too large, since they will need to be small enough to fall to the base of the Jug.
4Place the Lid onto the Jug to prevent splashing. The cutaway portion of the Lid will go over the pour spout side of the Blender Jug (see Figure 3). Place the Lid on the Jar at a slight angle and turn clockwise to lock into place (see Figures 4 and 5 nest page).
5Insert the plug into the wall outlet and turn the power switch on the side of the Motor Housing to the ON position.
6Press the P(ulse) button to operate the motor for a short period at high speed (pulse function) or press the I button for continuous low speed, or the II/FROZEN DRINK button for continuous high speed. The Standby Indicator Light will dim and the blue indicator light for the selected function will illuminate.
7
button with the lit indicator light). |
9 Remove the Jug from the Motor Housing by |
turning it counter clockwise 90 degrees and |
lifting straight up. |
Automatic Frozen Drink Mode |
• Your Blender is equipped with a special |
electronic function to make frozen drinks. |
Press the II/FROZEN DRINK button for |
more than 3 seconds to use this function. |
The Blender will automatically pulse on and |
off for approximately 22 seconds. This |
allows the ice cubes to fall back onto the |
chopping blades during processing, giving |
you an even, smooth texture. You can stop |
the automatic function at any time once |
your drink has reached the desired consis- |
tency by simply pressing the II/FROZEN |
DRINK button a second time. |
8