HSN_3n1BlenderManual 6/25/10 11:06 AM Page 13
Using Your Food Processor
with Slicing or Shredding Disc
| 1 | Place the appliance on a flat, stable, level |
|
| surface where it cannot fall. |
| 2 | Place the Mixing Bowl on the Motor Housing |
|
| with the handle at a 90 degree angle (see |
|
| Figures 6 & 7). Rotate the Mixing Bowl |
|
| clockwise as far as possible until you hear it |
Figure 13 | click into place. | |
3 | Slide the selected disc over the Accessory | |
|
| Shaft and ensure that the white center ring |
|
| on the Accessory Disc is flush with the |
|
| Accessory Shaft (see Figure 13) |
4 | Place the Lid on the Mixing Bowl as show in | |
|
| Figure 8 and rotate the Lid clockwise as far |
|
| as possible. The Lid’s protruding lip must be |
|
| slid over the Mixing Bowl’s handle. (See |
|
| Figure 9). |
5 | Pull the Power Cord out of the storage | |
|
| space at the rear of the Motor Housing. |
6 | Insert the plug into the wall outlet and turn | |
|
| the power switch on the side of the Motor |
|
| Housing to the ON position |
|
| If after plugging the cord in, all indicator |
|
| lights are flashing, the Mixing Bowl and/or |
|
| the Lid is not placed correctly on the Motor |
|
| Housing. For safety reasons it is not possible |
|
| to switch on the appliance in Food |
|
| Processor Mode UNLESS both bowl and Lid |
|
| are properly assembled. Check the position |
|
| of the bowl and the Lid and ensure that it |
|
| matches Figures 7 & 9. When the Mixing |
|
| Bowl and the Lid are fitted correctly, only |
|
| the Standby Indicator Light flashes. Only |
|
| then can the appliance be operated. |
7 | Press the I button for continuous low speed. | |
|
| The Standby Indicator Light will dim and the |
|
| blue indicator light will illuminate. |
8Add ingredients during use via the Food Chute in the Lid. Use the Food Pusher to push solid ingredients downwards through the filling opening. Do not push too hard, slow steady pressure is all that is needed. Too much pressure could damage the unit.
•Your
1)Time Protection: After two minutes of continuous operation, the motor will shut off. Fifteen seconds before switching off, the Standby Indicator Light will begin to flash. This prevents the motor from overheating during use; and
2)Overload Protection: In the event of an electrical overload, the motor will automatically shut off. Simply unplug the unit from the outlet. Wait at least 15 seconds before using again.
•To avoid personal injury or damage to the appliance, never insert a hand or another object into the Mixing Bowl while the appliance is operating.
•Always use the Food Pusher to push ingredients. Never use your fingers, a fork or another object to push ingredients.
9You can turn the motor off by pressing the Selected Speed button or if using the P(ulse) button, simply remove your finger from the button. Switch the power off by pressing the power switch, located on the right side of the Motor Housing and unplug from the wall outlet.
10Remove the Mixing Bowl by rotating counter clockwise and
lifting straight up. Remove the Processing Blade with the Accessory Shaft from the bowl before emptying. Remove the Cutting Disc from the Spindle by grasping from the white center ring and lifting straight up.
13 | 14 |