Hotpoint RGB506 installation instructions Seal the Openings, Light the Pilots

Page 30

INSTALLATION INSTRUCTIONS

(continued)

ELECTRICAL CONNECTIONS (continued)

BUsage Situations where Appliance Power Cord will be Disconnected Frequently.

Do not use an adapter plug in these situations because disconnecting of the power cord places undue strain on the adapter and leads to eventual failure of the adapter ground terminal. The customer should have the two-prong wall receptacle replaced with a three-prong (grounding) receptacle by a qualified electrician before using the appliance.

The installation of appliances designed for mobile home installation must conform with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or, when such standard is not applicable, the Standard for Manufactured Home Installations, latest edition (Manufactured Home Sites, Communities and Set-Ups), ANSI A225.1, latest edition, or with local codes. In Canada, mobile home installation must be in accordance with the current CAN/CSA Z240/MH Mobile Home Installation Code.

Electric Disconnect

1.Locate disconnect plug on the range back.

2.Pinch sides of connector and pull out of range back.

4 SEAL THE OPENINGS

Seal any openings in the wall behind the range and in the floor under the range when hookups are completed.

5 LIGHT THE PILOTS

(for models equipped with standing pilots)

The range should be installed in its permanent position before any pilots are lit or adjusted.

Light the Surface Burner Pilots

CAUTION: Make sure the surface burner control knobs are in the OFF position before attempting to light the pilots.

1.Raise the cooktop.

2.Light both pilots with a match. When both pilots are lit, adjust the top pilot adjustment until the pilots are approximately 1/8″ above the pilot cage with a very slight yellow tip.

Pilot cage

1/8″ Above the pilot cage

3.To avoid pilot outage, use caution when closing cooktop after lighting pilots.

Check Surface Burners

To check for proper lighting, push in and turn a surface burner knob to the LITE position. Each burner should light within four (4) seconds in normal operation. Once the burner lights, the knob should be rotated out of the LITE position. Try each knob separately until all burner valves have been checked.

NOTE: Do not leave standing pilot lit in a newly constructed or remodeled home or apartment that will be unoccupied for more than a month.

Each pilot flame was adjusted at the factory to be approximately 1/8″ above the pilot cage. A tinge of yellow appearing at the upper tip is normal. If you find pilot adjustment is necessary, follow instructions in this section for adjusting the surface burner pilots.

30

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Your Range Read this guide carefully Save time and money Before you request serviceÉHelp US Help Youé Write down the model and serial numbersImportant Safety Instructions If YOU Need ServiceImportant Safety Instructions When You Get Your RangeUsing Your Range Surface Cooking ¥ Do not leave any items on the cooktop Cleaning Your Range Save These InstructionsBaking, Broiling and Roasting Features of Your Range Features of Your Range Surface Cooking Lighting Instructions for Electric Ignition ModelsSurface Burner Controls Cooking How to Select Flame SizeSurface To Light a Surface BurnerPower Outage Using Your OvenBefore Using Your Oven Lighting Instructions for Standing Pilot ModelsShelf Positions Using Your OvenOven Shelves Oven VentsBaking How to Set Your Range for BakingPan Placement PreheatingBaking Adjust the Oven Thermostatñ Do IT YourselfRoasting Adjust the OvenQuestions and Answers ThermostatRoasting Guide Frozen RoastsRoasting Guide BroilingBroiling Guide Broiling Broiling GuideBroiler Pan and Grid Care and CleaningStandard Twin Burners After broiling, removeOven Bottom Care and CleaningBurner Grates Cooktop SurfaceLift-Up Cooktop Control Panel and KnobsOven Air Vents To raise the cooktopLift-Off Oven Door Porcelain Oven InteriorOutside of door Installation Instructions For Your SafetyImportant Safety Instructions Protect Your Floor Provide Adequate GAS Supply GAS Connection for Electric Iginition ModelsConnect the Range to GAS Checking Manifold GAS PressureElectrical Requirements Extension Cord CautionsIMPORTANT-Please read carefully Seal the Openings Light the PilotsSurface Burner Air Adjustment if Necessary Check Ignition of Surface Burners Electric Ignition ModelsYellow flames To adjust the air shutter Check Ignition of Oven BurnerTo remove the oven bottom Installing the 2-PIECE ANTI-TIP Device Prepare Range for Conversion Convert the Pressure RegulatorOr Converting Back to Natural Gas from LP Converting to LP GAS Convert the Surface Burner ValvesConvert the Oven Burner Spud Convert the Broil Burner SpudQUESTIONS? Before YOU Call for Serviceé Problem Possible CauseBefore You Call for Service We’ll Be ThereWarranty

RGB506 specifications

The Hotpoint RGB506 is a standout choice for consumers seeking a reliable and efficient range cooker that combines both style and functionality. This appliance epitomizes modern kitchen design while ensuring cooking needs are met with ease.

One of the key features of the Hotpoint RGB506 is its double oven design, offering a total capacity that accommodates family meals and entertaining guests effortlessly. The primary oven boasts a generous space of 70 liters, providing ample room for roasts, casseroles, and other culinary creations. The secondary oven adds an additional 38 liters of cooking space, ideal for baking or keeping dishes warm without occupying the main oven’s area.

In terms of cooking technology, the Hotpoint RGB506 is equipped with fan-assisted cooking, ensuring even distribution of heat throughout the oven. This technology allows users to cook multiple dishes at once without worrying about flavors mixing or uneven cooking results. Additionally, the double oven setup allows for multiple cooking methods; the main oven can be utilized for traditional cooking while the other can function as a grill, broadening culinary possibilities.

Another remarkable feature is the hob area, which includes four gas burners. These burners come with various power outputs, allowing for precise temperature control suited to different cooking styles, from gentle simmering to rapid boiling. The cast iron supports on the burners ensure durability and stability, providing a professional touch to home cooking.

Safety and convenience are paramount, and the RGB506 addresses these with its flame failure safety device. This feature automatically cuts off the gas supply if the flame goes out, offering peace of mind. The oven is also fitted with an easy-to-clean enamel interior, which simplifies maintenance and enhances the longevity of the appliance.

For those who appreciate design, the Hotpoint RGB506 features a sleek and modern aesthetic that can complement a variety of kitchen styles. Its clean lines, stainless steel finish, and ergonomic controls create a sophisticated yet accessible cooking environment.

In summary, the Hotpoint RGB506 is a versatile and efficient range cooker that combines ample cooking space, advanced technology, and a commitment to safety and ease of use. Its thoughtful design and functionality make it an excellent addition to any kitchen, whether for everyday cooking or special occasions.
Top Page Image Contents