15. Connect vent system to blower. Vent system must end with a wall or roof cap. Use duct tape to seal all joints.
16. Install cooktop according to manufacturer’s instructions. Check that rear of cooktop overlaps edge of retractable downdraft vent by 3/8" (9.5 mm).
To get the most efficient
use from your new
retractable downdraft vent,
read the Use and Care Information section on page 12.
Keep Installation
Instructions
and Use and Care
Information close by for
easy reference.
Exterior-mounted vent motor
KIRD and YKIRD |
| ||
MODELS ONLY |
|
| |
NOTE: |
|
| |
motor installations require exterior |
|
| |
blower system, Part No. |
|
| |
KPED890T, available from your |
|
| |
dealer or authorized parts supplier. |
|
| |
|
|
| |
Installation requirements |
| left vent | right vent |
|
|
| Roof venting |
|
|
| |
Island location |
|
| |
Built-in cabinet location(8.3 cm x 35.6 cm) vent
Maximum length of vent system
Vent | Length |
|
|
9" (22.9 cm) round | 55 feet (16.8 m) |
|
|
55 feet (16.8 m) | |
(8.3 cm x 35.6 cm) |
|
|
|
For best performance, use no more than three 90° elbows. If more than one elbow is used, make sure that there is a minimum of 24 inches
(61 cm) of straight vent between any two elbows. Do Not install two elbows together.
It is recommended that you use round vent instead of rectangular vent, especially if elbows are required. If rectangular vent is required, it should be transitioned to 9" (22.9 cm) round vent as soon as possible.
Determining the length of system you need:
To calculate the length of system you need, add the equivalent feet for each duct piece that will be needed. See example for 9"
(22.9 cm) round vent system.
9" (22.9 cm) round vent system
Maximum length = 55 ft. (16.8 m)
2 - 90 elbows | = 10 | ft. | (3 m) |
10 ft. (3 m) straight = 10 | ft. | (3 m) | |
|
|
|
|
Length of 9" |
|
|
|
(22.9 cm) system | = 20 | ft. (6.1 m) | |
Note: The
9