Jenn-Air W10274320C Range Hood Use, Install Vent Covers, Complete Installation, Display, A B G

Page 10
RANGE HOOD USE

8.Seal connections with vent clamps.

A WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

9.Plug 3 prong power cord into a grounded 3 prong outlet located above the range hood.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.

The range hood controls are located on the front side of the canopy.

A Install Vent Covers

B

G

Install Vent Covers

When using both upper and lower vent covers, push lower cover down onto hood and lift upper cover to ceiling and install with two 2.9 x 6.5 mm screws.

NOTE: For vented installations, the upper vent cover may be reversed to hide slots.

D

C

C DA

B

A. Upper vent cover

B. Lower vent cover

C. 2.9 x 6.5 mm screws

D. Bracket

Complete Installation

1.For non-vented (recirculating) installations only, install charcoal filters over grille on blower housing. See the “Range Hood Care” section.

2.Install metal filters. See the “Range Hood Care” section.

3.Check the operation of the range hood blower and light. See the “Range Hood Use” section.

NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.

C

F

 

D

E

A. Louver holes (non-vented

D. Grease filters

[recirculating] installations only)

E. Lamp housings

B. Duct covers

F. Grease filter handles

C. Canopy

G. Control panel

Control Panel

The range hood controls are located on the front side of the canopy.

A BCD E

A. Power decrease

B. Power increase

C.Display

D.Light

E.Timer

Display

Grease Filter Saturation Alarm

After 30 hours of fan function, the display will show “Clean Grease Filter” when the fan is active. When this icon shows in the display, the installed grease filters should be washed. See “Range Hood Care” section.

To reset the grease filter saturation alarm, press and hold the POWER INCREASE button for 5 seconds. The “Clean Grease Filter” icon will no longer be displayed.

10

Image 10
Contents LI3UUB/W10274320C Installation Instructions and Use & Care GuideInstructions d’installation et Guide d’utilisation et d’entretien Table of Contents/Table des matièresINSTALLATION REQUIREMENTS TABLE OF CONTENTSRANGE HOOD SAFETY INSTALLATION INSTRUCTIONSYour safety and the safety of others are very important RANGE HOOD SAFETYDANGER READ AND SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONSINSTALLATION REQUIREMENTS Tools and PartsCabinet Dimensions Product DimensionsFor Mobile Home Installations For vented installations, you will also needVenting Requirements Cold Weather InstallationsFor Non-Vented recirculating Installations vented models onlySAVE THESE INSTRUCTIONS Electrical RequirementsGROUNDING INSTRUCTIONS Electrical Shock Hazard Plug into a grounded 3 prong outletVent Cover Support Bracket Installation INSTALLATION INSTRUCTIONSRange Hood Mounting Screws Installation Excessive Weight HazardFor non-vented recirculating installation only Install Range HoodFor vented installations only Connect Vent SystemGrease Filter Saturation Alarm Install Vent CoversComplete Installation RANGE HOOD USEAudible Signal Activation and Deactivation TimerCharcoal Filter Saturation Alarm Charcoal Filter Recirculation Accessory Inclusion and ExclusionCleaning Method CleaningNon-Vented recirculating Installation Filters RANGE HOOD CARES3 S2 S1 WIRING DIAGRAMSE1X5A Electronic User InterfaceIf you need replacement parts ASSISTANCE OR SERVICEAccessories In the U.S.AITEMS EXCLUDED FROM WARRANTY This limited warranty does not cover JENN-AIR MAJOR APPLIANCE WARRANTYONE YEAR LIMITED WARRANTY DISCLAIMER OF IMPLIED WARRANTIES LIMITATION OF REMEDIESPage DANGER AVERTISSEMENT SÉCURITÉ DE LA HOTTE DE CUISINIÈREVotre sécurité et celle des autres est très importante IMPORTANTES INSTRUCTIONS DE SÉCURITÉ LIRE ET CONSERVER CES INSTRUCTIONSInstallation dans une résidence mobile EXIGENCES DINSTALLATIONExigences d’emplacement Dimensions du produitExigences concernant l’évacuation Dimensions du placardInstallation dans une région à climat froid seulement pour un modèle avec décharge à lextérieurMéthodes d’évacuation Installation sans décharge à lextérieur recyclageInstallation sans Décharge par larrièreINSTRUCTIONS DE MISE À LA TERRE AVERTISSEMENTSpécifications électriques CONSERVEZ CES INSTRUCTIONSInstallation des vis de montage de la hotte INSTRUCTIONS DINSTALLATIONPréparation de lemplacement Installation de la bride de cache-conduitInstallations sans décharge à lextérieur recyclage uniquement Installation de la hotteInstallations avec décharge à l’extérieur uniquement Raccordement du circuit dévacuationTableau de commande Installation des cache-conduitsAchever l’installation Alarme de saturation du filtre à graisseInclusion et exclusion du filtre à charbon accessoire de recyclage Alarme de saturation du filtre à charbonActivation et désactivation du signal sonore Power Increase/On augmentation de la puissance/ activéRemplacement du filtre à charbon Filtres dinstallation sans décharge à l’extérieur recyclageRemplacement d’une lampe à halogène ENTRETIEN DE LA HOTTESCHÉMA DE CÂBLAGE Tableau dalimentationAu Canada ASSISTANCE OU SERVICEAccessoires Si vous avez besoin de pièces de rechangeARTICLES EXCLUS DE LA GARANTIE GARANTIE DES GROS APPAREILS MÉNAGERS JENN-AIRGARANTIE LIMITÉE DE UN AN La présente garantie limitée ne couvre pasPage 12/09 W10274320C2009 All rights reserved