Jenn-Air 41007605 warranty Dimensions Leveling Legs, Level the Wine Chiller, Front Side Min

Dimensions

Leveling Legs

Front

3"

(7.6 cm)

Side

min. 34"

(86.4 cm) max. 35" (88.9 cm) with leveling legs fully extended

237⁄8" (60.6 cm)

471⁄4"

(120.0 cm)

Install leveling legs (located in literature pack):

•With at least two people, tip wine chiller backwards until there is approximately 12" (31 cm) of clearance between the floor and the wine chiller.

Weldnut

(each bottom corner of unit)

Bottom of

wine chiller

Leveling leg

(4 per wine chiller)

•Screw one front leveling leg into the screw impression found in each corner. Leveling legs should be screwed in until snug.

•Repeat the above procedures to install the rear leveling legs.

WARNING

•To prevent injury, one person should not attempt to tilt the wine chiller by himself. Have someone else assist to prevent the wine chiller from falling during leveling leg installation.

CAUTION

•The wine chiller should remain upright at least 30 minutes prior to plugging it in.

Level the Wine Chiller

22"

(55.9 cm)

241⁄4"

(61.6 cm)

Using a carpenter’s level, check to be sure the wine chiller is level from side to side and from front to back. Leveling adjustments can be made by turning the leveling legs counter-clockwise to increase height and clockwise to reduce height.

NOTE: The wine chiller should not wobble. Use shims to add stability when needed.

4