Extron electronic DVS 304 AD manual Rack mounting the DVS, Rack mounting a half rack device

Rack mounting the DVS 304

1.	If feet were installed on the bottom of the DVS 304, remove them.
2.	Place the DVS 304 on one half of the 1U (one unit high, one unit wide) rack
	shelf (part #60-190-01). Align the front of the DVS 304 with the front of the
	shelf, and align the threaded holes on the bottom of the DVS 304 with the
	holes in the rack shelf.
3.	Attach the DVS 304 to the rack shelf with the two provided 4-40 x 1/16"
	machine screws. Insert the screws from the underside of the shelf, and
	securely fasten them into diagonally-opposite corners (figure 2-1).

False front panel uses 2 front holes.

			(2) 4-40 x 3/16" Screws
		Use 2 mounting holes on
		opposite corners.
Figure 2-1 — Rack mounting a half rack device
4.	Attach the false front panel (provided with the universal rack shelf) to the
	unoccupied side of the rack (as shown above), or install a second half-rack-
	width device in that side by repeating steps 1 – 3.
5.	Attach the rack shelf to the rack using four 10-32 x 3/4" bolts (provided).
	Insert the bolts through #10 beveled washers, then through the holes in the
	rack ears and rack (figure 2-1).

DVS 304 • Installation and Operation 2-3