Extron electronic DVS 304 AD, DVS 304 D Menus, Configuration, and Adjustments, Menu overview

Installation and Operation, cont’d

Menus, Configuration, and Adjustments

Scaler configuration and adjustments can be performed by using the embedded Web pages and the Windows-based control program (see chapter 3, “Serial Communication” for details) or by using the front panel controls and the menus that are displayed on the DVS 304’s LCD screen. These menus are used primarily when the scaler is first set up.

Moving through menus by using front panel controls

Menu button — Press the Menu button to activate menus and scroll through the eight main menus.

Next button — Press the Next button to move between the submenus of a selected main menu. Pressing the Next button during input configuration causes the current input’s number and format type to be displayed on the LCD

Adjust ([,{) knobs — In configuration mode, rotate the Adjust horizontal ([) knob and Adjust vertical ({) knob to scroll through submenu options and to make adjustment selections. Refer to the flowcharts in this chapter and to specific sections for explanations on knob adjustments.

Menu overview

Power

on

The default menus appear on the LCD when no adjustments are actively being made. They cycle between the screen showing the model of the scaler (DVS 304 or DVS 304 A) and the screen that shows the active input’s number and video format, as shown below.

					Default Cycle
						2 sec.
EXTRON		60-736-01		INPUT 1		OUTPUT
DVS 304	2 sec.	FW ver. 1.xx	2 sec.	COMPOSITE	2 sec.	1024 x 768@60

Figure 2-8 — Default menus

NFrom any menu or submenu, after 20 seconds of inactivity the DVS 304 will save all adjustment settings and time-out to the default menus.

The main menus are shown on the following pages. Use the Menu button to scroll between them.

NIf no signal is present on the currently selected input, NO SIGNAL appears in place of a signal value, e.g. INPUT 4 NO SIGNAL.

2-10 DVS 304 • Installation and Operation