Extron electronic DVS 304 D, DVS 304 AD Resetting an Input, Exit menu, Using the swap feature

Using the swap feature

Use the swap feature to switch the active main window input with the current PIP input. For example if the main window is Input 4 (RGB scaled) and the PIP window is Input 1 (composite), applying the swap command results in Input 1 becoming the main window and Input 4 the PIP window.

For audio models (DVS 304 A or AD), you can allow audio to follow the main (default) or PIP window. Audio breakaway is not possible while PIP mode is on; audio must follow either the main window or the PIP window.

Exit menu

From this submenu, press the Menu button to return to the Start Auto Image menu cycle, or press the Next button to return to the default sequence.

	Default Cycle
		2 sec.
INPUT 1		OUTPUT
COMPOSITE	2 sec.	1024 x 768@60
	MENU
	START AUTO
	IMAGE ON IN1
	MENU
	INPUT	MEMORY
	CONFIG	PRESETS
	MENU	MENU
	PICTURE	IP
	CONTROL
		CONFIG
	MENU	MENU
	OUTPUT	ADVANCED
	CONFIG	CONFIG
	MENU	MENU
(Audio models only)	AUDIO	TO EXIT MENU	NEXT
	CONFIG	PRESS NEXT
	MENU	MENU
Figure 2-19 — Exit menu

Resetting an Input

Each input of the DVS 304 scaler can have their parameters reset to default values by holding down the specific input button together with menu button, until the input number and RESET message is displayed on the LCD screen.

DVS 304 • Installation and Operation 2-21