Ice Machine Operation | Section 3 |
|
|
Bin Door Removal
QF0400
Door removal allows easier access for cleaning and sanitizing.
1.Disconnect the electrical power to the ice machine and remove ice from bin.
2.Grasp the rear of the bin door and pull bin door forward approximately 5”.
3.Slide bin door to the rear while applying upward pressure (the rear door pins will ride up into the track slot).
4.Slide the rear door pins off the end and then below the door track. Slide bin door forward allowing the back of the door to lower into the bin. Continue forward with the bin door until the front pins bottom out in the track.
5.Lift the right side of the bin door until the front pin clears the track.
6.Remove door from bin.
Press Down to
Release Door 
Track Slot
Slide Door Forward
SV2068
Cabinet Removal
QF0400
1.Remove all ice from bin and disconnect power.
2.Remove thumbscrews and evaporator panel.
3.Remove three screws from the bottom of the left and right side of cabinet.
4.Remove nine screws from back panel.
5.Disconnect drain line clamp.
6.Slide cabinet forward and remove from base.
Remove 3 Screws
From Each Side
SV2044
Remove Back
Panel screws
SV2069
| Part Number |