Miele KM 81-2 operating instructions ÖConversion to alternative types of gas

Page 35

Conversion to alternative types of gas

Replacing the small jet for the lowest Checking the first intake of air flame setting

Remove screw d from fitting c using an 8 mm wrench and a 12 mm wrench to counterhold.

Then remove the screw fitting c from b using a 12 mm wrench and a second 12 mm wrench to counter- hold.

Replace the restrictor e contained in section b with the correct restric- tor from the table of jets (page 32).

Turn the air sleeve f to adjust the two air vents g to the opening illustrated (2 mm / 1/16").

Assemble removed parts in reverse order and check for leaks by opera- ting the wok burner without the cook- top cover in place (ignite the flame using a match).

bFastening screw

cAir sleeve

Gap X must be 13 mm / 1/2" for both natural and liquid gas.

If this is not the case, loosen the secur- ing screw, re-position the air jet and then tighten the securing screw.

Re-assemble the cooktop in the reverse order.

35

Image 35
Contents @äö Description of the appliance Stainless steel cover-EA Data plateContents For Canada only For your safetyDisposal of your old machine Help protect our environmentDisposal of packaging Important notes for the installer Important safety instructionsPage Page Save the Instructions Burner control BurnerPower cut Lids MaterialShape of woks, pots and pans Wok / Pan baseElectronic ignition Cleaning and careBurner caps Control panel / Control knob Wok/pan support, trivetCooktop surface Electric spark ignition for the gas burner no longer works? Problem solving guideShape and color of the flame are different from usual? Gas flame goes out after being lit?After Sales Service ÖElectrical connection Technical data CDN / USAElectrical connection NZ Technical data AUS NZ@äElectrical connection Electrical connection AUSÖGas connection For USA only Pressure regulator For CDN onlyNominal rating for all types of gas USA/CDN @äGas connection Nominal rating for all types of gas at the high settingAppliance dimensions Gas connection CDN/USA Gas connection AUS/NZ ÖInstructions for building-in Zone Combiset Place the seal provided f under the edge of the cooktop @äClearance above and around the appliance @äClearance above and around the appliance Data plate details @äInstallationInstallation @äInstallation @äInstructions for building-in Reference table jet sizes ÖConversion to alternative types of gasNatural gas Liquid gas ÖConversion to alternative types of gas After conversion Conversion @äConversion to alternative types of gasRemarks Natural gas Liquid gas @äConversion to alternative types of gas After conversion Page Page Page Alteration rights reserved / 22