SCN60
Installation and Use
How to remove scale from the ice making system.
Cleaning this machine involves adding a solution of scale remover and water to the ice machine and continuing to add it as it makes ice. The scale remover must be diluted to the correct ratio. A squirt bottle will make adding the scale remover much easier when the unit is built in. If not built in, remove the top panel for reservoir access.
Recommended tools: Rubber gloves, squirt bottle
&scale remover.
1.Scoop out and discard all of the ice.
2.Press and release the On/Off button.
Ice | Check | Time to | Clean | |
Reset | ||||
Making | Water | Clean | ||
|
3.Open door and locate screws at upper back wall of bin. Remove the two screws.
Ice | Check | Time to | Clean |
Reset | |||
Making | Water | Clean |
|
Screws |
| ||
4.Remove the back wall of the bin by lowering it down past the scoop holder, feel free to rotate the scoop holder loop down to make more room.
Float Valve |
On/Off Lever |
Reservoir Cover |
Release Tab |
5.Push tab on front edge of reservoir cover and remove the cover. Note: Adjacent wires are low voltage and are not hazardous.
Push In Tab to Release Cover
Lift Reservoir Cover to Remove
May 2011 Page 14