SCN60
Installation and Use
Door Swing
The door swing is reversible. | 6. Remove kickplate and front service panel. |
The door can be attached to open with hinges on the left or right using new hinge brackets shipped loose in the ice bin. Retain all screws for
To change:
1.Remove hinge cover and innermost screw holding each hinge to cabinet, loosen the other.
2.Slide hinges to the side and remove door from cabinet. Remove screws loosened in step 1 from both cross braces.
Ice | Check | Time to | Clean |
Reset | |||
Making | Water | Clean |
|
Screw Below |
7.Remove two front screws and two bottom screws holding the bottom door bracket to the cabinet.
8.Replace the bracket with the one supplied loose with the machine. Secure it using the original screws.
9.Remove the upper hinge and move it to the door’s opposite side, bottom location. Secure using the original screws.
3.Remove two screws securing top panel to back, pull top panel back and remove from cabinet.
Note: If door panel is attached, it must be removed to access hinge screws.
4.Remove two screws at the top and lift the upper bracket out of the cabinet. Replace with the one supplied loose with the machine.
10.Remove the original lower hinge and move it to the door’s opposite side, upper location. Secure using the original screws.
Remove Screws |
Fasten it to the cabinet using the original screws.
5.Return the top panel to the cabinet and fasten it with the original screws.
11.Install a screw removed in step 2 in outermost hole of upper and lower cross braces.
12.Attach the door to the cabinet using the original screws.
13.Return kickplate and front service panel to their original positions and attach to the cabinet using the original screws.
May 2011
Page 8