Scotsman Ice SCN60 dimensions Control System, Control Panel

Page 20

SCN60

Service

Control System

The control system operates the machine. The controller operates on 12 volts AC, supplied by the transformer. It uses an ultrasonic ice sensor to measure ice level. The ultrasonic system transmits sound waves into the ice storage bin and measures the return time, when the return time is longer than the preset time for bin full, the controller switches the ice machine to an ice making mode. During ice making the compressor, fan motor and auger motor are operating.

The control system has two safeties: It will not operate the machine without water and it will not operate the machine if the auger motor is drawing too much current or if it isn’t drawing any current. The water sensor is checking the conductivity of the water in the water reservoir. If there is no water in the reservoir the conductivity will be zero and the controller will either not start ice making or will stop making ice.

The current or amps of the auger motor are continually monitored by the controller during ice making. If the current is too high, indicating an overload, the controller will stop ice making. If the current is zero, indicating an auger motor failure, the controller will also stop ice making.

The control pad has two switches and three lights. The left switch button is On/Off. The right switch button is Clean/Reset. The left Ice Making light is a status light, it is ON when the machine has been switched to an ice making mode. The center light is a Water light, it will be ON when the controller has sensed that there is no water available. It will go out when the water supply has been restored. The right light is a Time to Clean indicator light. It is switched ON by the controller after six months of power connect time. It will go out after the machine has been cleaned following the process in the Maintenance section.

Glows Green when

Glows Yellow when

unit is switched On

it's time to clean the

 

machine

On/Off Control Button

Glows Red when there is no water

Clean Button

supplied to the machine

 

 

 

The machine will NOT make ice when this light is on. It will restart and the light will go out when the water supply is restored.

Control Panel

May 2011

Page 4

Image 20
Contents SCN60 IntroductionProduct Description Cabinet Dimensions Installation Notes Location RecommendationsFamiliarization Decorating Features Door Panel AttachmentDoor Panel Attachment Door Swing Drains Water Supply Drain Pump Model drain installationPlumbing Pump Model Plumbing Gravity Drain Model Installation check list Electrical and Start UpInitial Start Up Ice level controlUse NoiseIce Making Control PanelMaintenance Scotsman strongly recommends regularHow to remove scale from the ice making system Scoop out and discard all of the iceDrain Plug Other Maintenance BothService SCN60 serviceComponents Evaporator and Auger Control System Water System Storage Light Blink Information Controller ResetPerformance and Technical Specs Other Control Functions Safety Shut DownsElectrical Sequence Service Diagnosis Problem Likely Cause Probable SolutionWith power on and Ice Making light on Component Diagnostics Membrane Switch Pump Switch Pump model onlyCompressor Ice Level SensorIce Capacity Refrigerant chargeLubricants and Sealants Removal and ReplacementEvaporator construction SCN60 Gearbox Access & Removal Hazard of Electrical ShockSCN60 Water Seal Replacement Gear Reducer Replacement Ice Breaker ReplacementEvaporator Replacement Drain Pump if equipped Fan Blade or MotorCompressor replacement Bin and Cabinet Auger Motor or Motor Capacitor