GE ZSC1201SS, ZSC1202SS, PSB1201SS, PSB1200WW, PSB1200BB installation instructions Warming Drawer

Installation Preparation

Preparation WITH an Accessory Storage Drawer

NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4″.

MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.

PREPARE THE OPENING (cont.)

Installation over a GE/Monogram Oven:

PREPARE THE OPENING (cont.)

Installation over a GE/Monogram Oven and

30″

21″

36-3/4″

Min.

45-1/4″

Recommended*

23-1/2″

25-1/4″

Min.*

Construct Solid Bottom Min. 3/8″ Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides

2″ Min.

(3″ Recommended)

Per Oven

Requirement

*Required for Monogram models

Warming Drawer:

30″23-1/2″

						Construct Solid
						Bottom Min.
						3/8″ Plywood
			25-1/4″
						Supported by
			Min.*
						2 x 4 or 2 x 2
						Runners all
						Four Sides
21″
							2″ Min.
							(3″ Recommended)
					Per Oven
					Requirement
45-	1/4″						2″ Min.
							(3″ Recommended)
		Per Warming
		Drawer Requir		ement

*For existing cutouts, a maximum width of 28-1/2″is acceptable. If the opening is slightly wider, secure a furring strip on each side of the cutout for securing the oven.

•If you are replacing a GE/Monogram electric double oven with the combined installation of an Advantium 120V and a single oven, use

the dimensions shown. The middle rail separating the two openings may need to be larger than the 2″ minimum shown.

*For existing cutouts, a maximum width of 28-1/2″is acceptable. If the opening is slightly wider, secure a furring strip on each side of the cutout for securing the oven.

NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth

and height . See Warming Drawer installation instructions for details.

CAUTION:For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of this approximate 80-pound oven and 30-pound drawer, plus additional oven loads of up to

50 pounds or a total weight of 160 pounds.

10