GE PSB1200WW, ZSC1201SS, ZSC1202SS, PSB1201SS, PSB1200BB installation instructions 2″Min 2″Recommended

Page 8

Installation Preparation

Preparation WITHOUT an Accessory Storage Drawer

PREPARE THE OPENING (cont.)

Installation beside another GE/Monogram Built-in Speedcook Oven:

If you are mounting one Under-the-Counter GE/Monogram oven beside the other, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 4-1/2minimum shown.

17-1/2

25-1/4

23-1/2

25-1/4

17-1/2

4-1/2Min.

(5-1/2Recommended)

PREPARE THE OPENING (cont.)

Installation under a GE/Monogram 30or 36Cooktop or Countertop:

Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for the cutout size. See the label on top of the oven for approved cooktop models. This oven requires a separate, properly grounded 15-Amp, 120-Volt, 60Hz power supply. The cooktop requires a separate power supply. Use a 36or wider base cabinet .

Cooktop

23-1/2

1-1/2Min.

25

Cooktop

36

Countertop

Height

17-1/2

25-1/4

Cooktop height including depth of electrical box on some models. Refer to cooktop installation instructions.

No minimum clearance required between cooktop and oven.

4High Toekick

NOTE: The oven is only approved to be installed under the specific models as labeled on the unit.

8

Image 8
Contents Installation Instructions Contents Models AvailableSafety glasses or goggles Parts SuppliedAdvance Planning 8 ″Electrical Location Single Advantium 120 InstallationElectrical Requirements Single Advantium 120V Installation Prepare the OpeningInstallation over a GE/Monogram oven Installation over a GE/Monogram Oven and Warming DrawerDrawer 30″ 23-1/2″17-1/2″ 25-1/4″ ″ Min2″Min 2″Recommended 30″23-1/2″ 21 ″30″ 21″ 36-3/4″ Min 23-1/2″ 25-1/4″ Construct Solid All Four SidesWarming Drawer 21″ 25-1/4″ Cooktop Installation Instructions Slide the Oven Into the Cutout Discard plastic trim. Replace screwsFinalize Installation Install Bottom TrimInstall Mounting Screws ZX2201SS-Stainless Steel for installation above 36″ only Allow 15″ clearance When fully openTools Required JX2200BB-Black JX2201SS-Stainless SteelRemove Packaging and Parts Assembling the Oven to DrawerAssembling the Oven to Drawer Page GE Consumer & Industrial