Prepare the Opening

Installation Preparation

Preparation WITHOUT an Accessory Storage Drawer

The Advantium 120V can be installed in combination with other GE/Monogram appliances. Always follow each product’s Installation

PREPARE THE OPENING (cont.)

Installation over a GE/Monogram Warming Drawer:

Instructions to complete the installation.

Single Advantium 120V Installation:

Order a 30″ wide single oven cabinet or cut the opening in a wall to the dimensions shown.

30″23-1/2″

25-1/4″

17-1/2″

30″

17-1/2″

23-1/2″

25-1/4″

Construct Solid Bottom Min. 3/8″ Plywood Supported

by 2 x 4 or 2 x 2 Runners all Four Sides

2″ Min.

(3″ Recommended)

Per Warming

Drawer

Requirement

Construct Base Min. 3/8″ Plywood Supported by 2 x 4 or

2 x 2 Runners all Four Sides

•Allow 2-1/8″case trim overlap on the sides,

1-1/16″overlap on the top and 7/8″ overlap on the bottom of the opening for all models.

•Oven overlaps will conceal cut edges on all sides of the opening.

When installed over a single oven or a warming drawer, allow at least 2″ between the two openings. This separation will provide clearance for bottom overlap of the Advantium 120V and the other appliance overlaps.

Construct a solid oven floor of 3/8″ min. thick plywood supported by 2 x 4 or 2 x 2 runners on all sides.

•The support must be level and rigidly mounted, flush with the bottom edge of the cutout .

NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height . See Warming Drawer installation instructions for details.