30″ 23-1/2″, 21″ 25-1/4″ | GE ZSC1202SS, ZSC1201SS, PSB1201SS

Installation Preparation

Preparation WITH an Accessory Storage Drawer

NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4″.

MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.

PREPARE THE OPENING (cont.)

Installation over another GE/Monogram Under-the-Counter (UTC) oven:

PREPARE THE OPENING (cont.)

Installation under a GE/Monogram Microwave Oven and over a Warming

30″

23-1/2″

Drawer:

21″

25-1/4″

Construct Solid Bottom Min. 3/8″ Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides

2″ Min.

(3″ Recommended)

30″

Per Oven Requirement

23-1/2″

25-1/4″

Construct Solid Bottom Min. 3/8″ Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides

3.5″ Min.

(4.5″ Recommended)

21″*

*Profile models only

21″*

Per Warming Drawer Requirement

2″ Min.

(3″ Recommended)

*Profile models only

•If you are mounting an Under-the-Counter GE/Monogram oven over another, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2″ minimum shown.

NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth

and height . See Warming Drawer installation instructions for details.

CAUTION:For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of this approximate 80-pound oven, plus additional oven loads of up to 50 pounds

or a total weight of 130 pounds.