GE PSB1201SS, ZSC1201SS, ZSC1202SS, PSB1200WW, PSB1200BB Contents, Models Available

Page 2

Safety Information

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANTSave these instructions for local inspector’s use.

IMPORTANTObserve all governing codes and ordinances.

Note to Installer Be sure to leave these instructions with the Consumer.

Note to Consumer Keep these instructions with your Owner’s Manual for future reference.

Skill Level Installation of this appliance requires basic mechanical and electrical skills.

Completion Time 1 Hour.

Proper installation is the responsibility

of the installer. Product failure due to improper installation is not covered under the warranty. See Owner’s Manual for warranty information.

NOTE: This oven is only approved to be installed under the specific models as labeled on this unit.

IMPORTANTUse this oven only for its intended purpose. Never use the oven for warming or heating a room. Prolonged use of the oven without proper ventilation can

be hazardous.

CAUTION:

For personal safety, remove house fuse or oven circuit breaker before beginning installation

to avoid severe or fatal shock injury.

CAUTION:

For personal safety, the mounting surface

must be capable of supporting the cabinet load, in addition to the added weight of the 80-pound oven and 30-pound drawer, plus additional oven loads of up to 50 pounds or a total weight of up to 160 pounds.

CAUTION:

If installing the Advantium 120V Oven below 36, you must use the plastic bottom trim due to burn risk to children. The plastic trim acts as insulation and will help prevent burns to children from hot surfaces.

CAUTION:

If installing the Advantium 120V Oven below 36, do not remove the plastic door trim due to burn risk to children. The plastic trim acts as insulation and will help prevent burns to children from hot surfaces.

CONTENTS

 

Design Information

 

Models Available

2

Product Dimensions and Clearances

3

Tools and Parts Required

3

Parts Supplied

3

Electrical Tools and Parts Required

3

Advance Planning

3

Installation Preparation

 

Electrical Requirements

4

Install Junction Box

4

Preparing the Opening (Installation without

 

an accessory storage drawer)

5-8

Preparing the Opening (Installation with

 

an accessory storage drawer)

9-12

Installation Under a 36Cooktop

12

Installation Instructions

 

Step 1, Remove Packaging and Parts

13

Step 2, Install Door Trim

14

Step 3, Route Conduit

14

Step 4, Install Bottom Trim

15

Step 5, Install Mounting Screws

15

Step 6, Finalize Installation

15

MODELS AVAILABLE

 

Profile Models:

 

PSB1200WW–White*

 

PSB1200BB–Black

 

PSB1201SS–Stainless Steel

 

Monogram Models:

 

ZSC1201SS–Stainless Steel

 

ZSC1202SS–Stainless Steel**

 

*No color-matched drawer available for this model.

**This unit cannot be installed with an accessory storage drawer.

2

Image 2
Contents Installation Instructions Contents Models AvailableAdvance Planning Safety glasses or gogglesParts Supplied 8 ″Electrical Location Single Advantium 120 InstallationElectrical Requirements Single Advantium 120V Installation Prepare the OpeningInstallation over a GE/Monogram oven Installation over a GE/Monogram Oven and Warming Drawer17-1/2″ 25-1/4″ Drawer30″ 23-1/2″ ″ Min2″Min 2″Recommended 30″ 21″ 36-3/4″ Min 23-1/2″ 25-1/4″ Construct Solid 30″23-1/2″21 ″ All Four SidesWarming Drawer 21″ 25-1/4″ Cooktop Installation Instructions Slide the Oven Into the Cutout Discard plastic trim. Replace screwsFinalize Installation Install Bottom TrimInstall Mounting Screws Tools Required ZX2201SS-Stainless Steel for installation above 36″ onlyAllow 15″ clearance When fully open JX2200BB-Black JX2201SS-Stainless SteelRemove Packaging and Parts Assembling the Oven to DrawerAssembling the Oven to Drawer Page GE Consumer & Industrial