GE PSB1200BB, ZSC1201SS Slide the Oven Into the Cutout, Discard plastic trim. Replace screws

Page 14

Installation Instructions

2DOOR TRIM REMOVAL FOR ABOVE 36INSTALLATION ONLY

If installing the Advantium 120V Oven above 36from the floor, you may remove the plastic trim from the bottom of the door for esthetic purposes if desired.

CAUTION:If installing the Advantium 120V Oven below 36, do not remove the plastic door trim due to burn risk to children. The plastic trim acts as insulation and will help prevent burns to children from hot surfaces.

If installing above 36, remove the 3 screws that secure the plastic trim to the bottom of the door.

Discard plastic trim. Replace screws.

3 SLIDE THE OVEN INTO THE CUTOUT

CAUTION:Two people are required to lift the oven into the opening. Grasp the bottom

at front and rear. DO NOT USE THE HANDLE TO LIFT THE OVEN. DAMAGE WILL OCCUR.

Lift and hold the oven at the front of the opening. Hold the oven at an angle and plug in the power cord.

Carefully, slide the oven into the cabinet part way. Leave the oven a few inches forward of the cabinet frame.

Check to be sure the power cord is not trapped under the oven or along the sides of the oven.

14

Image 14
Contents Installation Instructions Contents Models AvailableAdvance Planning Safety glasses or gogglesParts Supplied 8 ″Electrical Location Single Advantium 120 InstallationElectrical Requirements Single Advantium 120V Installation Prepare the OpeningInstallation over a GE/Monogram oven Installation over a GE/Monogram Oven and Warming Drawer17-1/2″ 25-1/4″ Drawer30″ 23-1/2″ ″ Min2″Min 2″Recommended 30″ 21″ 36-3/4″ Min 23-1/2″ 25-1/4″ Construct Solid 30″23-1/2″21 ″ All Four SidesWarming Drawer 21″ 25-1/4″ Cooktop Installation Instructions Slide the Oven Into the Cutout Discard plastic trim. Replace screwsFinalize Installation Install Bottom TrimInstall Mounting Screws Tools Required ZX2201SS-Stainless Steel for installation above 36″ onlyAllow 15″ clearance When fully open JX2200BB-Black JX2201SS-Stainless SteelRemove Packaging and Parts Assembling the Oven to DrawerAssembling the Oven to Drawer Page GE Consumer & Industrial