Drawer, 30″ 23-1/2″, 17-1/2″ 25-1/4″, ″ Min

Installation Preparation

Preparation WITHOUT an Accessory Storage Drawer

PREPARE THE OPENING (cont.)

Installation over another GE/Monogram Under-the-Counter (UTC) oven:

PREPARE THE OPENING (cont.)

Installation under a GE/Monogram Microwave Oven and over a Warming

30″

23-1/2″

Drawer:

17-1/2″

25-1/4″

Construct Solid Bottom Min. 3/8″ Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides

2″ Min.

(3″ Recommended)

30″

Per Oven Requirement

23-1/2″

25-1/4″

Construct Solid Bottom Min. 3/8″ Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides

3.5″ Min.

(4.5″ Recommended)

17-1/2″

Per Warming Drawer Requirement

2″ Min.

(3″ Recommended)

•If you are mounting an Under-the-Counter GE/Monogram oven over another, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2″ minimum shown.

NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth

and height . See Warming Drawer installation instructions for details.

CAUTION:For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of this approximate 80-pound oven, plus additional oven loads of up to 50 pounds

or a total weight of 130 pounds.