GE C2S980 Operating Instructions Safety Instructions, Installation Instructions, Consumer Support

Page 4

Operating Instructions Safety Instructions

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING.

WARNING!

IMPORTANT SAFETY NOTICE

The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the state to cause birth defects or other reproductive harm, and requires businesses to warn customers of potential exposure to such substances.

Gas appliances can cause minor exposure to four of these substances, namely benzene, carbon monoxide, formaldehyde and soot, caused primarily by the incomplete combustion of natural gas or LP fuels. Properly adjusted burners, indicated by a bluish rather than a yellow flame, will minimize incomplete combustion. Exposure to these substances can be minimized by venting with an open window or using a ventilation fan or hood.

SAFETY PRECAUTIONS

When using electrical appliances, basic safety precautions should be followed, including the following:

Installation

Instructions

 

 

Troubleshooting Tips

■Use this appliance only for its intended purpose as described in this Owner’s Manual.

■Be sure your appliance is properly installed and grounded by a qualified technician in accordance with the provided installation instructions.

■Do not attempt to repair or replace any part of your range unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician.

■Before performing any service, disconnect the range power supply at the household distribution panel by removing the fuse or switching off the circuit breaker.

■Do not leave children alone---children should not be left alone or unattended in an area where an appliance is in use. They should never be allowed to sit or stand on any part of the appliance.

■Do not allow anyone to climb, stand or hang on the door, storage drawer, or cooktop. They could damage the range and even tip it over, causing severe personal injury.

■Do not store flammable materials in an oven or near the cooktop.

CAUTION: Items of interest to children should not be stored in cabinets above a range or on the backsplash of a range— children climbing on the range to reach items could be seriously injured.

SAFETY PRECAUTIONS

Have the installer show you the location of the range gas shut-off valve and how to shut it off if necessary.

Consumer Support

■Have your range installed and properly grounded by a qualified installer, in accordance with the Installation Instructions. Any adjustment and service should be performed only by qualified gas range installers or service technicians.

■Do not attempt to repair or replace any part of your range unless it is specifically recommended in this manual. All other service should be referred to a qualified technician.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Troubleshooting Tips Safety InstructionsWrite the model and serial numbers here Model # Serial # Operating Instructions Safety Instructions Installation ANTI-TIP DeviceAll ranges can tip and injury could result Troubleshooting Tips Consumer SupportGe.com Installation Instructions Operating Instructions Safety InstructionsConsumer Support Safety Safety Instructions Operating InstructionsLower Oven Drawer Instructions Safety Instructions Operating Installation InstructionsSupport Troubleshooting TipsUsing the gas surface burners SafetyInstructions Installation SupportUsing the griddle Safety InstructionsHow to Insert the Griddle Using the GriddleTroubleshooting Tips Case of Power FailureTop-of-Range Cookware Stove Top GrillsOperating Instructions Safety Instructions Using the upper oven controlsConsumer Support Troubleshooting Tips Using the upper oven Instructions OperatingBefore you begin… Upper Oven VentHow to Set the Upper Oven for Baking or Roasting Preheating and Pan PlacementOperating Aluminum FoilHow to Set the Upper Oven for Broiling-Close the oven door Broiling GuideHI Broil Broil HI/LO pad againInstructions Safety Using the clock and timerInstallation Instructions Tips Using the timed baking Roasting features upper oven only How to Set an Immediate Start and Automatic StopHow to Set a Delayed Start and Automatic Stop Operating InstructionsHow to Set the Upper Oven For Roasting When Using the Probe Using the probeInsert the probe into the food Using the convection oven Convection BakeConvection Roast Auto Recipe ConversionInstallation Instructions Troubleshooting Tips Multi-Shelf BakingCookware for Convection Cooking Paper and PlasticTouch the Convection Roast pad Convection Roasting Guide Using the timed convection Baking features upper oven only Make sure the clock shows the correct time of daySpecial features of your upper oven control Fahrenheit or Celsius Temperature SelectionHour Shut-Off Tones at the End of a Timed CycleSafety Gas/Control Lockout on some models InstructionsCook and Hold Hour, 24 Hour or Clock Black-OutHow to Set for Regular Baking/Roasting Using the Sabbath Feature. on some modelsHow to Exit the Sabbath Feature To Adjust the Thermostat Adjust the upper oven thermostat-Do it yourselfType of margarine will affect baking performance Using the lower oven drawer Adjust the oven thermostat-Do it yourselfOperating Instructions Safety To Use the Lower Oven DrawerUsing the self-cleaning upper oven Before a Clean CycleHow to Set the Upper Oven for Cleaning Instructions Operating InstructionsHow to Delay the Start of Cleaning After a Clean CycleTo start Touch the Start pad Sealed Burner Assemblies Care and cleaning of the rangeTurn all controls OFF before removing the burner parts Burner Caps and Heads Burner Grates Tips Consumer SupportCooktop Surface Griddle Precautions GriddleStainless Steel Surfaces on some models Griddle is to be used over the center burner onlyTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Oven Heating ElementsRemovable Lower Oven Drawer Glass WindowTo remove the drawer To replace the drawer Slide the drawer all the wayUpper Control Panel Oven Air VentsLower Control Panel and Knobs Oven Light Replacement Oven Shelves and Drawer RacksTo remove Do not remove any screws to remove the coverInstallation of the range Safety Instructions Operating InstructionsInstructions Installation If you smell gasInstallation Instructions Operating InstructionsDimensions and Clearances Operating Instructions Safety Gas line shut-off valveRecommended Gas Pipe Outlet Locations Safety Instructions Troubleshooting Tips Consumer SupportOperating Gas Supply RequirementsElectrical Power Supply Requirements Provide Proper Electrical SupplyRecommended Electrical Outlet Locations Locate the electric supply as illustratedConnect the Range to the Gas Supply Flexible Connector Hookup Rigid Pipe Hookup OptionsTeflon Registered trademark of DuPont Using an Existing Nema 14-50R Receptacle Replace the Power Cord OptionalRemove the wire cover on the back Do not discard these screwsWire Power Cord Installation Option Insert the new power cord through the strainWire Conduit Installation Option Replace the Wire Cover Wire Conduit Installation Option Safety InstructionsTips Consumer Oval Center Burner Head/Cap Assembly Seal the OpeningsAssemble Surface Burners CapsSafety Instructions Operating Check Ignition of Surface BurnersQuality of Flames Level the RangeInstructions Safety Install the Anti-Tip DeviceWhen All Hookups Are Completed Must be performed by a qualified LP gas installerTroubleshooting Tips Consumer Support Before you call for service…Problem Possible Causes What To Do Clock and timer Self-cleanAfter a clean cycle Is setSafety Instructions Operating Instructions Installation Wait for the self-clean cycle to finish and the oven Fully extend the drawer and push it all the wayTo cool Controls improperly set See the Lower oven drawer sectionAccessories Looking For Something More?Consumer Support We’ll Cover Any Appliance. Anywhere Anytime GE Service Protection PlusConsumer Product Ownership Registration GE Will Replace What GE Will Not CoverWarrantor General Electric Company. Louisville, KY One YearGE Dual Fuel Range Warranty. For customers in Canada Instructions Safety InstructionsMabe Will Replace What Mabe Will Not CoverInstallation Instructions Consumer Support GE Appliances Website
Related manuals
Manual 64 pages 46.44 Kb

C2S980 specifications

The GE C2S980,04-09 JR,49-85167-1,183D5580P249 is a sophisticated control system utilized in various industrial applications, specifically designed for enhancing efficiency and reliability. This model exemplifies advanced technologies and systems integration, catering to the needs of modern industries.

One of the main features of the GE C2S980 is its flexibility, allowing it to be integrated seamlessly into different types of systems. This adaptability makes it suitable for manufacturing plants, power generation facilities, and other industrial environments. The device is engineered for mobility and can be quickly deployed or modified according to the operational requirements of the facility.

A notable technology embedded within the GE C2S980 is its robust data acquisition capabilities. It can gather and process large volumes of data in real-time, which is crucial for effective monitoring and control. This feature enables operators to make informed decisions based on accurate and up-to-date information regarding equipment performance and system health.

Additionally, the GE C2S980 is equipped with advanced diagnostic tools. These tools assist in identifying faults and inefficiencies within the system, thereby reducing maintenance costs and minimizing downtime. Its built-in analytics engine helps in predictive maintenance, enabling industries to foresee potential issues before they escalate into serious problems.

The C2S980 also prioritizes user experience, featuring an intuitive interface that simplifies the navigation of complex controls. This user-friendly design reduces the learning curve for operators, enhancing overall productivity.

Another critical characteristic is its compliance with industry standards, ensuring safety and reliability in various applications. The system is designed to operate in challenging conditions and is built to withstand environmental factors, thus guaranteeing longevity and consistent performance.

In terms of connectivity, the GE C2S980 supports various protocols, facilitating interoperability with other devices and systems. This connectivity is essential for industries that rely on integrating multiple technologies into their operations.

Overall, the GE C2S980,04-09 JR,49-85167-1,183D5580P249 stands out due to its combination of advanced technology, user-centric design, and adaptability to diverse industrial environments, making it an invaluable asset for enhancing operational efficiencies.
Top Page Image Contents