Maytag MFI2266AEW Door Reinstallation, Pullout Freezer Drawer, Installation

Installation

Door Reinstallation Pullout Freezer Drawer

1.Install hinge assemblies:

• Install center hinges with Phillips or hex screws.

2.Place hinge side of refrigerator

door on center hinge pin.

• Install top hinge with 5⁄16” hex head screws.

3.While holding refrigerator door upright, tighten down top hinge with 5⁄16” hex head driver.

4.Reconnect connector.

5.Connect the waterline tubes firmly by pushing one waterline inside the other.

WARNING

To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before removing doors. After replacing doors, connect power.

CAUTION

To avoid possible injury, product, or property damage, you will need two people to perform the following instructions. Important: Always unload food in freezer trays before removing trays.

To Remove:

6. Slide the black locking collar fully forward.

7. Hold tabbed section of waterline.

8. Rotate black locking collar counterclockwise locking water lines in place. A “click” is heard ensuring Tabs waterlines are correctly locked in place. The “arrow” on the tabbed section should align with the 2 bars on the black locking collar.

9.Ensure the connection does not leak before installing the upper hinge cover.

10. Replace top hinge covers.

1.Pull drawer open to full extension.

Connector 2. Slide freezer bins forward and lift straight out.

3.Remove Phillips screws from each of the drawer slides.

4. Lift top of drawer front to unhook the drawer from the slides.

5.Move drawer slides fully forward.

6.Lift out lower drawer assembly.

6