WhisperKool PLATINUM 4000, PLATINUM 8000 owner manual Sizing the Unit to the Room

Page 12

Sizing the Unit to the Room

Model

Cellar Volume

AMP’s

AMP’s

Product Dimensions

 

 

 

 

 

 

(cubic feet)

(starting)

(running)

(W x H x D)

 

 

 

 

 

4000

1000

32

9

14.25” x 15.75” x 25.5”

 

 

 

 

 

8000

2000

36

10

14.25” x 22.5” x 27.5”

8000ti

2000 high

36

10

14.25” x 22.5” x 27.5”

8000ti

1000 med

36

10

14.25” x 22.5” x 27.5”

 

 

 

 

 

8000ti

500 low

36

10

14.25” x 22.5” x 27.5”

Cutting the Hole for the WhisperKOOL Unit

Tools Needed

Level

Hammer

Screwdriver

Saw

Locate the desired installation location. Using a stud finder, locate the studs on either side of the center point, and mark them with vertical lines.

Mark the horizontal lines with a level

Using a saw, cut along the uppermost horizontal line until your saw reaches the stud. Turn the saw around, inserting it into the cut you have just made, and cut toward the opposite stud so that you have a clean hori- zontal cut between the two studs. Be careful not to cut into the studs themselves.

Now make the second horizontal cut from stud to stud on the line 16” below the first cut.

Using a level and a pencil, mark a horizontal line on the wall between the two studs, approximately 1.25” (or as close as possible if more than 1.25”) from the ceiling.

Using a ruler or measuring tape, measure 16” down, and mark another horizontal line parallel to the first one.

Page 12

PT-EXPL 020111

Image 12
Contents For Platinum 8000tiPT-EXPL Table of Contents Whisperkool Series Quick Reference Guide Controller Quick Reference Guide FAN Speed ReferenceIntroduction Model Platinum 8000tiCustomer Warranty Registration Review the Packing Slip to Verify ContentsCheck the Accessory Kits for the following contents Receiving & Inspecting the UnitQuick Start Guide Preparing the Wine Cellar Wall & Ceiling FramingInsulation Vapor BarrierMounting the Unit Exhaust Fan Air Intake Cellar WallSizing the Unit to the Room Frame the hole with two-by-four supports Installation Electrical OutletTHROUGH-THE-WALL Installation without ductwork Mounting Flange PiecesPlacement of Unit Liquid Measuring Thermostat SystemLocation of Supply and Return Grilles Do notCondensation Drain Line Tube Drain LineInstallation Options Exterior Grille InstallationDucted Installation Cold Air to/from Wine CellarDucted Installation Standard Ducted Installation Insulation Box Condenser Exhaust Cold AirIntake Return AirAdjacent Room Wine Cellar Adjacent RoomReturn Air-Cellar Side SideLiquid Measuring Thermostat System To Use the thermostatRemote Controller Installation and Configuration Connection wire in Side Mount configuration Variable Speed Control Only on the 8000tiSystem Operation Standard & Remote Control Panel Features and Operation Button Normal FunctionsCpsm Alarm Codes Maintenance Schedule Troubleshooting Guide Unit does not run/power up Possible Cause SolutionCellar Temperature is to Warm Possible Cause Solution Unit leaks water Possible Cause Solution Unit runs but does not cool Possible Cause SolutionPossible Cause Solution Compressor short cycles Possible Cause SolutionAccessories for Cooling Units Contact WhisperKOOL Customer ServiceTechnical Assistance Installation Terms and Conditions WhisperKOOL Cooling SystemProduct Installation Requirements Installed by Date Sales and USE TAXPage WhisperKOOL