WhisperKool PLATINUM 4000, PLATINUM 8000 Remote Controller Installation and Configuration

Page 24

REMOTE CONTROLLER: INSTALLATION AND CONFIGURATION

The WhisperKOOL Extreme Series can be configured with a remote controller system. If you have a unit with a remote controller, please review this section.

The controller can be installed up to 50 feet away from the cooling unit, or up to 300 feet away with the extend- ed connection wire.

To install the remote controller, remove the mounting bracket and secure the bracket to the wall in the desired location. Reattach the controller to the bracket.

Mounting Bracket

Attach the connection wire as shown below, with the red wire in the upper connection slot and the black wire in the lower slot.

Red Wire

Black Wire

Page 24

PT-EXPL 020111

Image 24
Contents For Platinum 8000tiPT-EXPL Table of Contents Whisperkool Series Quick Reference Guide Controller Quick Reference Guide FAN Speed ReferenceIntroduction Model Platinum 8000tiCustomer Warranty Registration Review the Packing Slip to Verify ContentsCheck the Accessory Kits for the following contents Receiving & Inspecting the UnitQuick Start Guide Preparing the Wine Cellar Wall & Ceiling FramingInsulation Vapor BarrierMounting the Unit Exhaust Fan Air Intake Cellar WallSizing the Unit to the Room Frame the hole with two-by-four supports Installation Electrical OutletTHROUGH-THE-WALL Installation without ductwork Mounting Flange PiecesPlacement of Unit Liquid Measuring Thermostat SystemLocation of Supply and Return Grilles Do notCondensation Drain Line Tube Drain LineInstallation Options Exterior Grille InstallationDucted Installation Cold Air to/from Wine CellarDucted Installation Standard Ducted Installation Insulation Box Condenser Exhaust Cold AirIntake Return AirAdjacent Room Wine Cellar Adjacent RoomReturn Air-Cellar Side SideLiquid Measuring Thermostat System To Use the thermostatRemote Controller Installation and Configuration Connection wire in Side Mount configuration Variable Speed Control Only on the 8000tiSystem Operation Standard & Remote Control Panel Features and Operation Button Normal FunctionsCpsm Alarm Codes Maintenance Schedule Troubleshooting Guide Unit does not run/power up Possible Cause SolutionCellar Temperature is to Warm Possible Cause Solution Unit leaks water Possible Cause Solution Unit runs but does not cool Possible Cause SolutionPossible Cause Solution Compressor short cycles Possible Cause SolutionAccessories for Cooling Units Contact WhisperKOOL Customer ServiceTechnical Assistance Installation Terms and Conditions WhisperKOOL Cooling SystemProduct Installation Requirements Installed by Date Sales and USE TAXPage WhisperKOOL