U-Line 2115WC, 2275DWRWS, 2175WCOL, 2275DWRWOL, CLRCO2175, CO2175F COMPRESSOR/COIL Specifications

CAUTION

If frost is heavy, divert water from drain to prevent water from overflowing on the floor.

SPECIFICATIONS

CLR2160

COMPRESSOR/COIL SPECIFICATIONS

DANGER

Electrocution can cause death or serious injury. Burns from hot or cold surfaces can cause serious injury. Take precautions when servicing this unit.

•Disconnect the power source.

•Do not stand in standing water when working around electrical appliances.

•Make sure the surfaces you touch are not hot or frozen.

•Do not touch a bare circuit board unless you are wearing an anti-static wriststrap that is grounded to an electrical ground or grounded water pipe.

•Handle circuit boards carefully and avoid touching components.

To measure the start winding resistance measure across the C and S pins.

To measure the run winding resistance measure across the C and R pins.

Also check S to R and you should get the sum of the run and start windings.

To ensure the windings are not shorted check the S and R to ground.

THERMISTORS

The U-Line Model CLR2160 uses two thermistors. The thermistors are used in conjunction with the control panel to monitor the unit’s functions and troubleshooting capabilities. A type 1 thermistor is attached to the condenser dryer inlet and senses temperature after the condenser to signal length of ice- making and harvesting time. A type 2 thermistor senses the ice level in the ice bin and maintains ice level in the bin.

REED SWITCH

None on this model.