U-Line 2175BEV, 2275DWRWS, 2175WCOL, 2275DWRWOL Ice Cube Thickness Adjustment, Interval AS Required

Section 3 - Service and Repair

Ice Cube Thickness Adjustment

INTERVAL - AS REQUIRED

Ice thickness adjustments are made using the control panel as follows:

1.To enter the thickness adjustment mode:

a.Touch and hold the UP ARROW button.

b.Touch and release the DOWN ARROW button three times, then release the UP ARROW button.

c.The display will switch to “0” to confirm the thickness adjustment mode has been selected.

2.The factory setting is “0,” and the total range of adjustment is -5 to +5 (ideal range is -1 to +1). Use the UP ARROW button to raise the setting and thicken the ice bridge, or the DOWN ARROW button to lower the setting to thin the ice bridge.

IMPORTANT

Ice thickness adjustment should only be made one increment at a time. Allow ice maker production to stabilize for 24 hours before rechecking ice thickness.

3.Touch and release the LIGHT button key to exit the ice thickness adjustment mode.

4.Remove all ice from the storage bin.

Sample area

ULIN_0063_A

Figure 56

Ice cubes in any given batch will vary, so it is necessary to choose cubes from the sample area for comparison when making adjustments. If further adjustments are desired, repeat Steps 1 through 4.

The ice cube thickness is factory set for best overall performance. The factory setting is designed to maintain an ice bridge of approximately 1/16" to 1/8" under normal conditions resulting in a dimple of approximately 1/4" to 1/2" in depth. A fuller cube with less of a dimple results in a thicker ice bridge. As the ice bridge becomes thicker, the tendency for the cubes to stay together as a slab increases. A bridge thicker than 1/8" may cause cubes to overfill the ice bucket.

			BRIDGE	BRIDGE
1/4" TO 1/2"	1/16" TO 1/8"		TOO THIN	TOO THICK
		DIMPLE		LITTLE OR
DIMPLE	ICE BRIDGE
		TOO DEEP		NO DIMPLE

GOOD BAD

Cube Types

ULIN_0300_A

Figure 57

3-54