![](/images/new-backgrounds/1080184/80184157x1.webp)
Section 3 - Service and Repair
WATER SUPPLY CONNECTION
When connecting the water supply, follow these guidelines:
•Review the local plumbing codes before you install the unit.
•Connect to the cold water supply.
•The water pressure should be between 20 and 120 psi.
•The water line MUST have a
•Leave approximately 8’ of water line to be coiled behind the appliance (Figure 77). The water line should be looped into 2 coils. This will allow the unit to be removed for cleaning and servicing. However, make certain that the tubing is not pinched or damaged during installation.
IMPORTANT
WATERHOOKUP.
If using the flexible water supply kit, follow the instructions included with the kit.
To connect to 1/4” copper line water supply:
1.Locate the desired cold water supply location. Attach a 1/4” copper line to this location and route the tubing to the appliance. Leave approximately 8’ of water line to be coiled behind the appliance. The water line should be looped into 2 coils. This will allow the line to flex when removing the unit for cleaning and servicing (Figure 77).
ULIN_S_165 |
Figure 77
2.Locate the
9/16" Wrench
1/4" Copper Water
Supply Line
7/16" Wrench
From Water Supply
to Ice Maker
ULIN_S_0168_A
Figure 78