WhisperKool 5000TIR owner manual Mounting Bracket Installation, Applying Insulation Tape

Page 16

THROUGH-THE-WALL INSTALLATION (without ductwork)

Mounting Bracket Installation

There are four individual mounting brackets, one for each side of the unit. There will be two long brackets and two short brackets: upon receiving the unit these brackets will be located on top of the packaging foam on top of the unit. These brackets are designed to mount toward the rear of the unit and mount to the exterior side of the cellar wall. On each panel of the unit there are two half-shears for each bracket, and four different locations for mounting the brackets. Align the holes on the mounting bracket with the half shears on the unit, depending on the desired mounting location, secure using the 1/2” self tapping screws provided. Refer to the illustration below for the location of the half shears.

#1

#2. Retrofit your current WhisperKOOL cooling unit

#3

#4

Back of unit

Front of unit

Applying Insulation Tape

Locate the four precut pieces of black foam tape included with the system. There should be two larger pieces and two smaller pieces. Once you have at- tached the flange pieces to the unit, peel back the white-paper adhesive covering and place on the corresponding size of flange. The large pieces are applied to the side and the smaller pieces to the top and bottom. This foam creates a tight seal between the flange and the wall.

Page 16

PT-EXPL5000 060311

Image 16

Contents For 5000ti 5000tiR PT-EXPL5000 Table of Contents Whisperkool Series Quick Reference Guide Quick Controller Reference Guide Standard Controller Layout XR70CXUnit Specification FAN Speed ReferenceCustomer Service IntroductionCustomer Warranty Registration Review the Packing Slip to Verify ContentsCheck the Box for the following contents Receiving & Inspecting the UnitQuick Start Guide Preparing the Wine Cellar Wall & Ceiling FramingInsulation Vapor BarrierMounting the Unit Exhaust Fan Air Intake Cellar WallSizing the Unit to the Room Frame the hole with two-by-four supports Installation Electrical InletsMounting Bracket Installation Applying Insulation TapePlacement of Unit Liquid Measuring Thermostat SystemLocation of Supply and Return Grilles Do notCondensation Drain Line Tube Drain LineInstallation Options Exterior Grille InstallationLiquid Measuring Thermostat System To Use the thermostatRemote Controller Installation and Configuration Connection wire in Side Mount configuration Multi Speed Control System Operation Standard Controller Functions XR70CX Button Normal FunctionsEnergy Reduction Alarm Codes Standard Wire Schematic XR70CX Remote Controller Functions XW260K TemperatureBlink, confirming the change in Set Point Cpsm Mode Remote Wire Schematic XW260K Maintenance Schedule Unit does not run/power up Possible Cause Solution Cellar Temperature is to Warm Possible Cause SolutionUnit leaks water Possible Cause Solution Unit runs but does not cool Possible Cause SolutionPossible Cause Solution Compressor short cycles Possible Cause SolutionAccessories for Cooling Units Contact WhisperKOOL Customer ServiceTechnical Assistance Condensate Pump KitInstallation Terms and Conditions WhisperKOOL Cooling SystemProduct Installation Requirements Installed by Date Sales and USE TAXPage Page WhisperKOOL