WhisperKool 5000TIR Quick Controller Reference Guide, Standard Controller Layout XR70CX

QUICK CONTROLLER REFERENCE GUIDE

Standard Controller Layout - XR70CX

If your unit is installed through the wall and does not have a remote keypad you will have the XR70CX Controller

Note: The 1 or 3-5 qualifies the amount of time in seconds that the button must be pushed to activate the

feature. Refer to page 25-27 for complete instructions.

Energy Saving

Button 1

Energy Reduction

Set Button

•View Set Point 1

•Change Set Point 3-5

•SET + Down = CPSM 10-15

•Reset Hi & Lo Button 3-5

Display and modify set point. In programming mode it selects a parameter con￿rms an opera- tion. Hold for 3 seconds when the min or max temperature is displayed to RESET.

Defrost Compressor Evaporator and Condenser Fan

Hi Bottle Temp History & Scroll

Button 1

Push to see the max stored temperature. In programming mode use to browse the parameter codes or increase the display value. Hold for 3 seconds to start fast freezing cycle.

ALARM Pre-Chill Display

Evap. Coil is 26°, turns off when coil reaches 40°

Cellar “Pre-Chill” Button 3-5

Low Bottle Temp History & Scroll

Button 1

Push to see the min. stored temperature. In programming mode use to browse the parameter codes or decrease

the displayed value1 .

Control “ON/OFF” Button

•Turns the Cooling Unit

“ON/OFF”

Remote Controller Layout - XW260K

If your unit has a remote keypad then you will have the XW260K controller

Note: The 1 or 3-5 qualifies the amount of time in seconds that the button must be pushed to activate the

feature. Refer to page 29-31 for complete instructions.

Inactive

Set Button

•View Set Point 1

•Change Set Point 3-5

•SET + Down = CPSM 3 - 5

Defrost Compressor Evaporator and Condenser Fan

Hi Bottle Temp History & Scroll

Button 1

Cellar “Pre-Chill” Button 3-5

Push to see the max stored temperature. In programming mode use to browse the parameter codes or increase the display value. Hold for 3 seconds to start fast freezing cycle.

•Reset Hi & Lo Button 3-5

Display and modify set point. In programming mode it selects a parameter con￿rms an opera- tion. Hold for 3 seconds when the min or max temperature is displayed to RESET.

DIXELL

ALARM Pre-Chill Display

Low Bottle Temp History & Scroll Button 1

Push to see the min. stored temperature. In programming mode use to browse the parameter codes or decrease

the displayed value1 .

Control “ON/OFF” Button

•Turns the Cooling Unit

“ON/OFF”

Page 5