WhisperKool 5000TIR owner manual Installation Options, Exterior Grille Installation

Page 19

INSTALLATION OPTIONS

Exterior Grille Installation

The exterior grille is required on all installations where the condenser side of the unit is exposed to the outside of the dwelling (i.e. rain and weather).

STEP 1:

Now determine at what depth the unit will be installed:

• For a non-flush installation (i.e. holes location #2 WhisperKOOL retrofit or #1 Middle Wall or #3), place the grille on the condenser end and line up the holes on the grille with the holes on unit location #4. Use the 8 self tapping screws provided to fasten the grille to the unit.

•For a flush installation, place the grille on the condenser side and then place the mounting bracket over the grille sides, “stacking” them. Align the holes and fasten with the 8 self-tapping screws provided.

* It is required to use self tapping screws provided. Do not drill screws into unit.

Non-Flush Installation

Flush Installation

Page 19

Image 19

Contents For 5000ti 5000tiR PT-EXPL5000 Table of Contents Whisperkool Series Quick Reference Guide Standard Controller Layout XR70CX Quick Controller Reference GuideFAN Speed Reference Unit SpecificationIntroduction Customer ServiceReceiving & Inspecting the Unit Customer Warranty RegistrationReview the Packing Slip to Verify Contents Check the Box for the following contentsQuick Start Guide Vapor Barrier Preparing the Wine CellarWall & Ceiling Framing InsulationMounting the Unit Air Intake Cellar Wall Exhaust FanSizing the Unit to the Room Frame the hole with two-by-four supports Electrical Inlets InstallationApplying Insulation Tape Mounting Bracket InstallationDo not Placement of UnitLiquid Measuring Thermostat System Location of Supply and Return GrillesDrain Line Condensation Drain Line TubeExterior Grille Installation Installation OptionsTo Use the thermostat Liquid Measuring Thermostat SystemRemote Controller Installation and Configuration Connection wire in Side Mount configuration Multi Speed Control System Operation Button Normal Functions Standard Controller Functions XR70CXEnergy Reduction Alarm Codes Standard Wire Schematic XR70CX Temperature Remote Controller Functions XW260KBlink, confirming the change in Set Point Cpsm Mode Remote Wire Schematic XW260K Maintenance Schedule Cellar Temperature is to Warm Possible Cause Solution Unit does not run/power up Possible Cause SolutionCompressor short cycles Possible Cause Solution Unit leaks water Possible Cause SolutionUnit runs but does not cool Possible Cause Solution Possible Cause SolutionCondensate Pump Kit Accessories for Cooling UnitsContact WhisperKOOL Customer Service Technical AssistanceWhisperKOOL Cooling System Installation Terms and ConditionsProduct Installation Requirements Sales and USE TAX Installed by DatePage Page WhisperKOOL