WhisperKool 5000TIR owner manual Sizing the Unit to the Room

Page 13

Sizing the Unit to the Room

Model	Cellar Volume	AMP’s	AMP’s	Product Dimensions

	(cubic feet)	(starting)	(running)	(W x H x D)

5000ti/tiR	1000 high	32	7.2	14.25” x 16” x 28”

5000ti/tiR	1000 med	31	6.4	14.25” x 16” x 28”
5000ti/tiR	1000 low	30	5.9	14.25” x 16” x 28”

Cutting the Hole for the WhisperKOOL Unit

Tools Needed

Level

Hammer

Screwdriver

Saw

Locate the desired installation location. Using a stud finder, locate the studs on either side of the center point, and mark them with vertical lines.

Mark the horizontal lines with a level

Using a saw, cut along the uppermost horizontal line until your saw reaches the stud. Turn the saw around, inserting it into the cut you have just made, and cut toward the opposite stud so that you have a clean hori- zontal cut between the two studs. Be careful not to cut into the studs themselves.

Now make the second horizontal cut from stud to stud on the line 16 1/4” below the first cut.

Using a level and a pencil, mark a horizontal line on the wall between the two studs, approximately 1 1/2” (or as close as possible if more than 1 1/2”) from the ceiling.

Using a ruler or measuring tape, measure 16 1/4” down, and mark another horizontal line parallel to the first one.

Page 13

Image 13

Contents For 5000ti 5000tiR PT-EXPL5000 Table of Contents Whisperkool Series Quick Reference Guide Standard Controller Layout XR70CX Quick Controller Reference GuideFAN Speed Reference Unit SpecificationIntroduction Customer ServiceReview the Packing Slip to Verify Contents Customer Warranty RegistrationCheck the Box for the following contents Receiving & Inspecting the UnitQuick Start Guide Wall & Ceiling Framing Preparing the Wine CellarInsulation Vapor BarrierMounting the Unit Air Intake Cellar Wall Exhaust FanSizing the Unit to the Room Frame the hole with two-by-four supports Electrical Inlets InstallationApplying Insulation Tape Mounting Bracket InstallationLiquid Measuring Thermostat System Placement of UnitLocation of Supply and Return Grilles Do notDrain Line Condensation Drain Line TubeExterior Grille Installation Installation OptionsTo Use the thermostat Liquid Measuring Thermostat SystemRemote Controller Installation and Configuration Connection wire in Side Mount configuration Multi Speed Control System Operation Button Normal Functions Standard Controller Functions XR70CXEnergy Reduction Alarm Codes Standard Wire Schematic XR70CX Temperature Remote Controller Functions XW260KBlink, confirming the change in Set Point Cpsm Mode Remote Wire Schematic XW260K Maintenance Schedule Cellar Temperature is to Warm Possible Cause Solution Unit does not run/power up Possible Cause SolutionUnit runs but does not cool Possible Cause Solution Unit leaks water Possible Cause SolutionPossible Cause Solution Compressor short cycles Possible Cause SolutionContact WhisperKOOL Customer Service Accessories for Cooling UnitsTechnical Assistance Condensate Pump KitWhisperKOOL Cooling System Installation Terms and ConditionsProduct Installation Requirements Sales and USE TAX Installed by DatePage Page WhisperKOOL